AirStage UTY-DTGY Manual de instalação - Página 7
Procurar online ou descarregar pdf Manual de instalação para Controlador AirStage UTY-DTGY. AirStage UTY-DTGY 7 páginas. Touch panel controller
Imprimir página51 51
Installation method
▪
Install the switch box in advance to the wall to which the touch
panel controller is to be installed.
(1)
Installation procedure
Verify that the
power supply cable and transmission cable are
wired to the switch box.
Peel the cable covering.
Decide the path the
power supply cable and transmission cable are
to follow up to the terminals of the touch panel controller.
After passing the
power supply cable and transmission cable
through the specified holes of the installation plate, fix the instal-
lation plate to the switch box using screws.
Adjust the tilt of the installation plate by installing the accessory
washers.
In addition, pass the
power supply cable and transmission cable
through the wiring hole of the rear cover and fix the rear cover
using the tapping screws (M4 x 8mm, 2 screws) supplied with the
installation plate.
Next, fix the rear cover to the wall using the 2 accessory screws
(M4 x 20mm) and accessory washers.
Fix the cables at 2 places by binders.
7
Provide a surplus of 5mm or more from the end of the covering of
8
the cable and fix the part which is fixed by the binders.
Fix the
power supply cable and transmission cable to their re-
9
spective terminal so that there is no mistake.
Tightening torque
Power supply
cable
Transmission
cable
Insert the connector of the connection cable.
Close the front cover and rear cover. Align the claw of the bottom
of the front cover and fit the top to the rear cover.
Tighten the 2 screws at the side of the
@
power supply cable
Switch box
Hole in wall
Installation plate
power supply
@
cable
Screw
Washer
Screw
Binder
Touch pen tray
1.2 to 1.8 N • m
(10.7 to 15.9 lbf • in)
0.8 to 1.2 N • m
(7.1 to 10.6 lbf • in)
main unit.
Transmission
cable
Transmission
cable
Binder
Harness
Connection cable
(2)
Installation of touch pen
Touch panel
controller
Hole for
strap
Strap
There is a hole for a strap
Touch pen
which suspends the touch
pen at the main unit.
Use it so that the touch pen
will not be dropped or lost.
*
61
TURNING ON THE POWER
CAUTION
Check that the power supply voltage is within the specified range.
If a power supply voltage outside the specification is input, it will
cause trouble.
Recheck the wiring. Incorrect wiring will cause trouble.
After installation work is completed, check the following contents:
Is touch panel controller
power supply cable and transmission
cable wiring work complete?
Does the power supply match the rating of the touch panel con-
troller?
Turn on the touch panel controller
no power switch at the main unit, turn on the power by means of
the power distribution panel.
If the following installer setting screen is displayed at the screen
of the touch controller panel, installation work is complete.
For setting and operating of the touch panel controller, refer to the
separate operating manual.
*
Since there is some kind of
a problem when the installer
setting screen does not
appear, recheck the work
contents.
Hole for
strap
There are holes for a strap at
both sides of the main unit.
Install at the easiest hole to
use.
main unit power. Since there is
En-6