Carl's Place Pro Enclosure Kit Instruções de montagem e manual do utilizador - Página 12

Procurar online ou descarregar pdf Instruções de montagem e manual do utilizador para Desporto & Ar livre Carl's Place Pro Enclosure Kit. Carl's Place Pro Enclosure Kit 17 páginas.
Também para Carl's Place Pro Enclosure Kit: Instruções de montagem e manual do utilizador (20 páginas), Instruções de montagem e manual do utilizador (20 páginas)

Once the L fitting is reinstalled, attach the front sleeve to the top of the frame and secure with one bungee.

Next, stretch the bottom sleeve to the back and secure with one bungee. Then, stretch the corner grommet to

the frame corner using two bungees (one connecting in each direction.) Alternate from top to side, adding

more bungees to continue to stretch the panel until all grommets are attached with bungees.

Tip: place the bungee ball on the inside for a clean look once it is fully assembled.

Repeat by installing the left wall panel.

Due to the difference in elasticity between the wall panel fabric and the reinforced vinyl edges, you may need

to apply extra tension at the corner grommet to straighten out any sharply curving edge. This can be

accomplished using the zip-tie method described earlier.

It is normal for the gap between the wall panel and the frame to vary across the depth and height of the

frame. The elastic nature of the fabric means that the bungees will always pull it tight where it can stretch. The

reinforced edges stop the panel from fully stretching at the corner.