BDS 409 Manual de instruções - Página 4
Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica BDS 409. BDS 409 4 páginas. Heavy duty long arm riverter
Imprimir página
Thread for
nose pieces
Fig.1
TO CHANGE THE RIVETER NOSE PIECES
1. Select the proper nose piece size
desired.
2. Simply remove and replace the one
located on the end of the extension
as shown in Fig.2 with the wrench
supplied.
TOOL OPERATION
1. To install a rivet, open the handles outward as far as they will go.
2. Put the desired size rivet in the end that corresponds with the installed nose piece.
3. With the handles spread wide, push the rivet into the pre-drilled hole and put a slight amount of
pressure on the rivet and work piece. Then squeeze the handles together until the rivet head pops
loose from the mandrel.
4. Sometimes one squeeze will not be sufficient to separate the rivet from the mandrel as longer and
larger diameter rivets may require more than one squeeze.
5. Re-spread the rivet handles and slide the nose piece against the rivet button and squeeze once
again till the rivet pops loose from the mandrel.
CAUTION
When breaking the riveter loose from the rivet, please assume a firm stance as you may lose your
balance, which could result in serious injury.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Nose pieces
Nose pieces
Nose piece
Fig.2
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
Nose piece wrench
Bottle
n i
o f
@
s
w
s
a t
l h
d .
e