Drayton Digistat+ 3 22087 Manual de instalação
Procurar online ou descarregar pdf Manual de instalação para Termostato Drayton Digistat+ 3 22087. Drayton Digistat+ 3 22087 2 páginas. Programmable room thermostat
Também para Drayton Digistat+ 3 22087: Manual de instalação e do utilizador (2 páginas)
Imprimir página
Drayton
Programmable Room
Thermostat
7 Day (5-2 Day)
Models:
22083 / 22087
Power Supply:
Battery / Mains
Invensys Controls Europe
Technical Helpline: +44 (0) 845 130 7722
www.draytoncontrols.co.uk
Installation / User Guide 06490044001 (0905)
Installation Guide
Warning
If you do not have the knowledge to install the Digistat+3 safely,
arrange for a competent electrician to install it for you. Wiring
should conform to the current IEE wiring regulations. Isolate
mains supply before removing an existing room thermostat and
fitting Digistat+3.
Digistat+3 programmable room thermostats are double
insulated therefore Neutral and Earth connections are not
required. Unused existing cables should be safely insulated.
Location
Care should be taken to mount the
Digistat+3 on a wall, in a postion
which is not subject to direct
sunlight or draughts. Preferably it
should be mounted on an inside
wall about 1.5M (5ft) above the
floor in a position where it can
respond to room temperature but
away from the direct influence of radiators or other appliances
giving off heat.
Installation
1. Remove the front cover using a flat screwdriver and separate
from back plate (Fig 1).
2. Fix the back plate directly onto the wall using suitable wall
plugs and screws or mount over existing wall box (Fig 2).
3. Complete the wiring according to the connection suggestions
shown in Fig 3. For Basic boiler, Combi boiler and Basic boiler
with zone valve applications Digistat+3 with battery or mains
supply are suitable. For Electric Heat application use
Digistat+3 with mains supply only.
4. Replace the front cover by locating in position and pushing
fully onto the back cover (Fig 4).
5. Remove the battery cover using a coin (Fig 5). Battery model only.
6. Install the 2 AA batteries provided (Fig 6). Battery model only.
7. Replace battery cover (fig 7). Battery model only.
8. The Digistat+3 is now installed and will automatically start to
control the room temperature according to the pre-set
program 1 as shown in the User Guide.
The display shows the correct time and date which is
automatically set together with the actual room temperature.
(Fig 4)
(Fig 1)
(Fig 2)
(Fig 3)
(Fig 5)
(Fig 7)
(Fig 6)