Carlisle Tension-Finder Manual de instruções do utilizador

Procurar online ou descarregar pdf Manual de instruções do utilizador para Ferramentas Carlisle Tension-Finder. Carlisle Tension-Finder 2 páginas.

The Tension-Finder Tool Can Be Used to Tension Individual V-Belts or V-Bands.

–

The Tension-Finder tool should be used only with the belts listed in Table 1

–

The Tension-Finder tool should NOT be used with aramid, glass or carbon cord belts

WARNING: REMOVE THE TENSION-FINDER TOOL FROM THE BELT BEFORE STARTING THE DRIVE.

PROCEDURE:

Step 1:

Install belts loosely on the drive.

Step 2:

Apply enough tension to take the slack out of the belts.

Step 3:

Scribe a line on the belt using the Tension-

Finder tool as a square. For cog belts, see

the special instructions on page 2.

Step 6:

Scribe a line at the spring end of the Tension-

Finder tool. Use this line as a reference point

in case the spring slips off the belt.

USER INSTRUCTIONS

Step 4:

Place the Start Slot over the line.

Step 7:

Determine the required slot for your drive

from Table 1. Tighten the belt until the line

has moved to the designated slot. (In this

photo, the line is in Slot 3.)

V-Belt Tensioning Device

Step 5:

With the line in the Start Slot attach the spring

to the belt. Note: For cog belts, the best place

for the spring may be in between the cogs.

Step 8:

Remove the Tension-Finder tool from the belt,

tighten mounting bolts, and replace belt guards.

You're ready to start the drive!

Tension-Finder Tool User Instructions