Drazice OKCE 160 NTR Manual de operação e instalação - Página 8
Procurar online ou descarregar pdf Manual de operação e instalação para Caldeira Drazice OKCE 160 NTR. Drazice OKCE 160 NTR 18 páginas. Tank-type water heater for vertical
mounting
Também para Drazice OKCE 160 NTR: Manual de operação e instalação (13 páginas), Manual de operação e instalação (19 páginas)
Imprimir página
2 OPERATION AND FITTING INSTRUCTIONS
2.1 OPERATING CONDITIONS
The tank shall only be used in accordance with the conditions specified on the power plate
and in instructions for electric wiring. Besides legally acknowledged national regulations
and standards, also conditions for connection defined in local electric and water works have
to be adhered to, as well as the installation and operation manual.
The temperature at the place of heater installation must be higher than +2°C; and the room
must not freeze. The appliance has to be mounted at a convenient place; it means that
the appliance must be easily available for potential necessary maintenance, repair or
replacement, as the case may be.
If water is strongly calcareous we recommend that any of the common decalcifying devices
was installed with the appliance, or that the thermostat was set to the minimum operating
temperature of 60
water of adequate quality shall be used. To avoid potential sediments we recommend that
the device was installed together with a water filter.
2.2 WALL MOUNTING
Prior to the mounting check the bearing capacity of the wall and the material it is made of,
considering the weight of the heater filled with water. Depending on the wall material
choose adequate fixtures.
Should you have any doubts regarding the wall bearing capacity, consult the suspension with
a building specialist.
The minimum diameter of the bolts for suspending the heater is 12 mm. When mounting
the anchor bolts follow the guide provided by the anchor bolts' manufacturer.
Mount the anchors by the dimensional drawing on Figure 2 in 450 mm spacing. Double check the torque
of the suspension bolts on the heater and suspend the heater. Using the detent support in the bottom part
of the heater make sure it runs in parallel with the wall!
o
C (setting to position "60") - Figure 8. For proper operation, drinkable
Figure 3
- 8 -