Bosch Series 4 Manual do utilizador - Página 15

Imprimir página

10 Defrosting

10.1 Defrosting in the refri-

gerator compartment

When the appliance is operating,

condensation droplets or frost form

on the rear panel of the refrigerator

compartment due to functional reas-

ons. The back panel in the refriger-

ator compartment defrosts automatic-

ally.

Condensation runs through the con-

densation channel into the drainage

hole to the evaporation pan and does

not have to be wiped away.

To ensure that the condensation can

drain and odours do not form, ob-

serve the following information:

→ "Cleaning the condensation chan-

nel and drainage hole", Page 16.

11 Cleaning and servi-

cing

To keep your appliance working effi-

ciently for a long time, it is important

to clean and maintain it carefully.

Customer Service must clean inac-

cessible points. Cleaning by cus-

tomer service can give rise to costs.

11.1 Care instructions for

stainless steel surfaces

When taking care of and cleaning

stainless steel surfaces, use only

cleaning cloths and cleaning agents

suitable for stainless steel.

Tips

¡ To prevent visible scratches, wipe

the stainless steel surface in the

direction of the grain.

¡ Suitable cleaning agents and

cleaning cloths are available from

our customer service, your dealer

or on our website.

11.2 Preparing the appliance

for cleaning

Switch off the appliance.

→ Page 13

Disconnect the appliance from the

power supply.

Unplug the appliance from the

mains or switch off the circuit

breaker in the fuse box.

Take out all of the food and store it

in a cool place.

Place ice packs (if available) onto

the food.

If there is a layer of hoarfrost, allow

this to defrost.

Remove all fittings and accessor-

ies from the appliance.

→ Page 16

11.3 Cleaning the appliance

WARNING

Risk of electric shock!

An ingress of moisture can cause an

electric shock.

Do not use steam- or high-pres-

▶

sure cleaners to clean the appli-

ance.

Liquid in the lighting or in the con-

trols can be dangerous.

The rinsing water must not drip

▶

into the lighting or controls.

ATTENTION!

Unsuitable cleaning products may

damage the surfaces of the appli-

ance.

Do not use hard scouring pads or

▶

cleaning sponges.

Do not use harsh or abrasive de-

▶

tergents.

Defrosting en