Anchor ACL-7500U1 Manual do Proprietário - Página 4
Procurar online ou descarregar pdf Manual do Proprietário para Altifalantes Anchor ACL-7500U1. Anchor ACL-7500U1 4 páginas. Portable lectern sound system
Imprimir página
BASIC SYSTEM OpERATION
NOTE: Fully Charge Battery Before First DC Use!
1. Set all Input Level Controls to minimum & Tones Controls to flat (the
middle setting) before turning your system on
2. Plug lectern gooseneck microphone into the Lectern Mic Jack located on
the tabletop
3. Plug reading light into the Reading Lamp Jack on control panel
4. Switch POWER to ON, the BATTERY LED will light
5. Slowly increase the Level Control for the input jacks used
to the desired volume
6. Adjust BASS & TREBLE controls to desired sound quality
IMpORTANT: Make all connections w/ shielded
cables to avoid hum, buzzing or interference.
UHF WIRELESS RECEIVER
Available on selected models only
(please see page 6 for instructions)
READING LAMP JACK
Remove cap to use
ACCLAIM LECTERN - CONTROL pANEL
Model Shown: ACL-7500U1
4
CHARGE INDICATOR LIGHT
(please see page 3 for instructions)
BATTERY LEVEL INDICATOR LIGHT
ACCLAIM LECTERN -
CONNECTION pANEL
Model Shown: ACL-7500U1
POWER ON
TONE CONTROLS
Bass & Treble
INDICATOR LIGHT
LINE IN LEVEL
CONTROL
Waste electrical and electronic products must not be disposed of with household
waste. Please recycle where facilities exist. Check with your Local Authority or
Retailer for recycling advice.
AUXILIARY MICROPHONE
INPUT JACK – XLR
Balanced - low impedance mi-
WIRED MICROPHONE
crophones, powers condenser
LEVEL CONTROL
LECTERN MIC LEVEL
CONTROL
INPUT JACK – 1/4" PHONE
Jack may be combined w/ mic inputs for a composite output
For playback of tape/CD player or other audio source
OUTPUT JACK – 1/4" PHONE
Balanced - provides combined
output of all active system inputs
Record presentation / connect to another
BALANCED MICROPHONE
OUTPUT JACK – XLR
Use to connect Acclaim to a
house system
mics
LECTERN
MICROPHONE
JACK
FRONT/SPEAKER
LECTERN TOP
ACCLAIM LECTERN
- TABLETOp
All Models
BACK/CONTROL PANEL
LINE IN
LINE OUT
powered sound system
INTERNAL SPEAKER SWITCH
Turn internal lectern speaker out-
put on / off
SPEAKER OUT
OUTPUT JACK – 1/4" PHONE
Balanced - drives an unpowered
2 ohm speaker in addition to the
built-in speakers