Anchor AN-1000X Manual do Proprietário - Página 6
Procurar online ou descarregar pdf Manual do Proprietário para Altifalantes Anchor AN-1000X. Anchor AN-1000X 7 páginas. Anchor mic-25: product brochure
Também para Anchor AN-1000X: Manual do Proprietário (4 páginas), Manual do Proprietário (4 páginas), Especificações (1 páginas), Catálogo (2 páginas), Manual do Proprietário (4 páginas)
Imprimir página
100-26-0/D, ANX 2/6/01 9:40 AM Page 11
Operation
AN-1000X Rear Panel
two-way powered monitor
Power Switch
POWER
FUSE
AC Cord Receptacle
Operating the system
1. Place the AN-1000X at desired listening location.
2. Plug the power cord into a grounded AC outlet.
3. Plug an audio source into one of the three input jacks
on the back panel:
ALWAYS use
shielded audio
• LINE IN; RCA jack
cables on all
• LINE IN; 1/4-inch phone jack
input connec-
• BALANCED INPUT; XLR jack (*see below)
tions to prevent
interference
4. Set the volume knob on front panel to minimum,
then turn power switch on back panel ON (the red
LED on the front panel of the unit should light).
5. Adjust the volume bass and treble for desired sound
output.
* The BALANCED INPUT jack is set at the factory for
microphone-level inputs with 15 volts DC phantom
power. See page 6 for instructions on how to change
the configuration of this input jack.
6
Speaker Output
Line Input
(1/4"-phone jack)
(RCA jack)
Line Output
SPEAKER OUT
(RCA jack)
(8 OHM)
LINE OUT
Line Input
LINE IN
(1/4"-phone jack)
MIC
LINE
Balanced Input
BALANCED
INPUT
Switch
Balanced Input
(3-pin XLR jack)
Operation
Balanced Input
The balanced XLR jack input allows the AN-1000X to be
used in a variety of applications. The input can be configured
by the user for use with Lo-Z microphone or bridging
balanced line-level inputs (such as used in the pro-audio and
rubber grommet
broadcast industry). In addition, the input has 15 volt
phantom power which may be switched on or off.
To set the input, remove the rubber grommet just above
the XLR input to expose the configuration switch. With a
small pointed object, slide the three dip switches to the con-
BALANCED
INPUT
figuration required as shown below.
MIC LEVEL
phantom power ON
factory setting
Line Inputs
The line-level inputs (RCA and 1/4"-phone) may be used
with input sources such as VCR's, cassette and CD players,
LINE IN
musical instruments, computers, mixing consoles, etc. Both
inputs may be used simultaneously on the AN-1000X—the
volume control will control the composite program output.
Line Output
LINE OUT
The line-level output provides a replica of the composite
input signal. Use it for direct recording, or to daisy-chain
additional powered sound systems to the AN-1000X for
greater crowd coverage.
NOTE: All line-level connections must be made with shielded
cable to avoid hum, buzzing or radio interference.
Speaker Output
SPEAKER OUT
(8 OHM)
The external speaker output jack (1/4"-phone, unswitched)
allows the user to power an auxiliary unpowered speaker
(such as the AN-1001X). The auxiliary speaker must have a
minimum impedance of 8 ohms.
MIC LEVEL
LINE LEVEL
phantom power OFF
phantom power OFF
7