Anchor AN-1000X+ Manual do Proprietário - Página 4
Procurar online ou descarregar pdf Manual do Proprietário para Altifalantes Anchor AN-1000X+. Anchor AN-1000X+ 4 páginas. Speaker monitor
Também para Anchor AN-1000X+: Manual do Proprietário (6 páginas), Manual do Proprietário (14 páginas), Manual de início rápido (2 páginas), Manual do Proprietário (14 páginas), Manual do Proprietário (12 páginas)
Imprimir página
AN-1000X+ Speaker Monitor Owners Manual
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CONDITION
No Sound (Power LED Not Lit)
No Sound (Power LED Lights)
Distorted Sound
Excessive Hum / Noise
Mic Volume Too Low
Blows Fuse w/ Auxiliary Speaker
AN-1000X+ TECHNICAL SPECIFICATIONS
Rated Power Output
50 watts continuous @ 4W
Max SPL @ Rated Power 107 dB @ 1 meter
Frequency Response
65 Hz – 20 kHz ± 3 dB
Speaker Type
4.5" woofer with shielded magnet,
10mm dome tweeter
AC Power Reqs.
110 – 125VAC, 50/60 Hz,
75W Max
Export Model
208 – 240VAC, 50/60 Hz,
75W Max
Fuse Rating
T 1.0A / 250V
Export Model
T 0.5A / 250V (internally mounted)
Dimensions (HWD)
5.25" x 8.4" x 9"
(13 x 21 x 23 cm)
Weight
9.5 lbs / 4.3 Kg
Tone Controls
POSSIBLE CAUSE
• turn POWER switch on
• plug in power cord
• check for blown fuse
• check for output from source
• make sure all cables are completely plugged in
• increase volume control
• check input cable connection
• lower input signal level
• use shielded input cable
• set balanced input to mic-level
• shorted speaker cable
Anchor Audio customer service
800.262.4671
For AdditionAL inFormAtion
visit www.anchoraudio.com
Bass
+8 – 12 dB @ 100 Hz
Treble
+10 – 12 dB @ 10 kHz
Inputs
Balanced
female XLR, switchable phantom
power, 15 volts DC @ 6.8 kW
Mic-Level Setting
Lo-Z
Line-Level Setting
Bridging (10 kW)
Line
Hi-Z, unbalanced, 1/4"-phone &
RCA
Outputs
Line (post fader)
Lo-Z, buffered, RCA
Speaker
8W, unswitched, 1/4"-phone
Sensitivity For Rated Output
Line
balanced -18 dBv (125 mVrms)
Microphone
balanced -56 dBv (1.5 mVrms)
Line
-18 dBv (125 mVrms)
(Specifications Subject to Change Without Notice)
Anchor Audio products are warranted to be free from defects in materials and workmanship
for the period of SIX (6) YEARS from the date of original purchase unless listed below, which
are warranted for a period of TWO (2) YEARS:
- All wired and wireless microphones, beltpack transmitters, base station transmitters,
base station receivers, and hands-free microphones
- Rechargeable batteries
- All woodworking
- CouncilMAN microphones and bases
- PortaCom and ProLink 500 systems in their entirety
- Assistive Listening systems in their entirety
- Accessories, cables, cases, and covers
Warranties are subject to the following conditions:
- Product must have been purchased from an authorized Anchor Audio Dealer
- Anchor Audio must perform or authorize all warranty services or warranty is void
- Warranty is void when equipment is subjected to negligent use, connection to improper
power sources, misuse, and operation beyond specifications and limits
- Warranty shall not apply to exterior finish, AC power cords, bulbs, or any other failings
due to normal wear
- Warranty is void when equipment is subjected to adverse temperature, humidity,
moisture, or any condition not considered normal environmental conditions
- Products out of warranty cannot be repaired by Anchor Audio
To locate an authorized dealer near you, please contact [email protected]. Please
contact Technical Support at www.AnchorAudio.com/techinical-support-form.html to with
any questions, to begin the Return Authorization process, or to verify your warranty period.
General Warning or Caution
The Exclamation Symbol in the figure above appears in Warning and Caution tables
throughout this document. This symbol designates an area where personal injury or
damage to the equipment is possible.
Electric Shock
The Electrical Shock Symbol in the figure above appears throughout this manual. This
symbol indicates a hazard arising from dangerous voltage. Any mishandling could result in
irreparable damage to the equipment, and personal injury or death.
Electrical Shock Symbol
Protective Conductor Terminal
The Electrical Shock Symbol in the figure above appears throughout this manual. This
symbol indicates a hazard arising from dangerous voltage. Any mishandling could result in
irreparable damage to the equipment, and personal injury or death.
Figure Protective Conductor
Terminal Symbol
European Union CE Mark European Union CE Mark
The presence of the CE Mark on Anchor equipment means that it has been designed,
tested and certified as complying with all applicable European Union (CE) regulations and
recommendations.
Waste Electrical and Electronic Equipment (WEEE)
This symbol on the product or on its packaging indicates that this product must not be
disposed of with regular waste. Instead, it is the user responsibility to dispose of waste
equipment according to the local laws. The separate collection and recycling of the waste
equipment at the time of disposal will help to conserve natural resources and ensure that
it is recycled in a manner that protects human health and the environment. For information
about where the user can drop off the waste equipment for recycling, please contact
your local Anchor representative. See Section for instructions on how to disassemble the
Figure WEEE Directive Symbol
equipment for recycling purposes.
MADE IN USA
SIX YEAR WARRANTY
4