Dreadbox RAINDROPS Manual - Página 2

Procurar online ou descarregar pdf Manual para Pedal de música Dreadbox RAINDROPS. Dreadbox RAINDROPS 3 páginas.

A. Send an Audio signal or an instrument to the input (mono signals it's better to be send to the R INPUT)

B. Connect the Output to an Amp or a Monitor (mono signals should to be pulled out of the L OUTPUT)

C. Power the effect by using a 9VDC center pin negative power adapter (specialized for effect pedals)

D. Press the ON footswitch to enable the effect

E. Press both footswitches to change algorithms

F. To engage the secondary functions (SHIFT page) press and hold down the ON footswitch. While this is on hold, you have access to different parameters

G. In order to save the current algorithm's settings, press and hold both footswitches for 3 seconds

MODE

HOLD

DOWN

SHIFT

These are the SHIFT controls, that you can access while holding down the

ON button. Remember, in order to store this so that the pedal remembers

them the next time you power it, you must press and hold both footswitch-

es for 3 seconds!

TIME = EFFECT GAIN

Controls the level of the signal going into the effect's line. By default, this

should be set at 50%, but in many cases, for example if you plug a hot

signal instrument, you might need to set this lower, so that the effects do

not peak.

TAILS

FEEDBACK = POST FEEDBACK

This will control the amount of feedback that is send after the effect's

OFF

section. For example, feedbacks after the Pitch Shifter will introduce the

shimmer effect. Be carefully though, as this feedback control and the main

III

one will add up and self-oscillation can be produced.

NOTE: On the reverb's algorithm, this control is deactivated.

MIX = LOW PASS FILTER

This controls the Cut Off of a 1-pole Low Pass Filter.

CONTROL = TAP DIVISIONS

This is actually a multiplication over the tap tempo. It has fixed areas over

4 selections and it's x1, x2, x3, x4.

MODE toggle switch

Tails ON/OFF ( ON = 1, OFF = 2). By setting this to ON, will allow the repeats

of the delay to be kept on even when the effect is set to by pass.