Anchor Acclaim 2 Manual do Proprietário - Página 8
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de púlpito Anchor Acclaim 2. Anchor Acclaim 2 11 páginas. Portable lectern
Imprimir páginaTECHNICAL SPECIFICATIONS
Acclaim 2 Technical Specifications
Rated Power Output 22 watts AC/DC
Max SPL @ Rated Power 113 dB @ 1 meter
Frequency Response 60 Hz – 17 kHz ± 3 dB
Wireless Frequency 1.9 GHz DECT
Microphone Wireless Range 300'+ line of sight
USB 5v 500mA
Battery One 12v LFP rechargeable batteries, 7.0 AH
19v DC / universal input / 60 watts
Charger (RC-2)
(110vAC - 240 vAC, 50 - 60Hz)
Warranty (Woodwork) 2 years
Warranty (Electronics) 6 years
Inputs
Lectern Microphone Lo-Z, balanced phantom power, XLR
Wired Microphone Lo-Z, unbalanced, 1/4" phone
Line Input Hi-Z, unbalanced, 1/4" phone
outputs
Line Output (post fader) Lo-Z, 1/4" phone
Speaker Out 4W, unswitched, 1/4" phone, 20W max
Dimensions
Base (HWD) 30.5" x 21.5" x 19" (77.5 x 54.6 x 48.3 cm)
Tabletop Lectern (HWD) 21.5" x 15.5" x 8.5" (54.6 x 39.4 x 21.6 cm)
Weight
Base 42.5 lbs / 19.3 Kg
Tabletop Lectern 29.5 lbs / 13.4 Kg
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
Wireless Mic will not Connect to System
Connected Wireless Mic but No Sound
HAVING TROUBLE WITH YOUR SOUND SYSTEM?
CoNDItIoN poSSIbLe SoLUtIoNS
• Turn POWER switch ON
No Sound (Power LED: OFF)
• Check battery level, charge battery, or plug in AC cord
• Ensure the gooseneck mic is properly inserted into the XLR input
• Check your source audio and turn up volume of source audio
No Sound (Power LED: ON)
• Make sure all cables are completely plugged in
• Turn up volume control of input used
• Check battery level of microphone
• Un-pair all microphones from the system then re-pair the microphones
• Check the Mute button on the microphone or belt pack
• Raise volume on the microphone and system
(Solid Green LED)
• Check battery level of microphone and system
• Check battery level of microphone and system
• Re-position system away from any possible interference sources
Poor Wireless Range /
• Raise system onto a higher level (speaker stand)
Poor Wireless Audio Quality
• Minimize obstructions between the system and wireless microphone
• If wireless range continues to be poor, call Anchor Audio Tech Support
• Check battery level, charge battery, or plug in AC cord
• Lower system volume
Distorted Sound
• Lower source audio volume
• Wireless belt pack - ensure Mic and/or Line Level setting is correct
• Lower the volume on the microphone (handheld or belt pack)
Excessive Feedback (Squelching)
• Do not stand within at least 10 feet in front of the speaker with the mic(s)
• Use shielded cables (Example: EX-50PPS)
Excessive Hum or Noise
• Use a balanced microphone
Gooseneck Mic (LM-618) Technical Specifications
Mic Element Type
Electret Condenser (requires phantom power)
Polar Pattern
Unidirectional, Cardioid
Frequency Response
500 - 18,000 Hz
Sensitivity
-70 ± 3 dB (0 dB = 1 volt/microbar)
Output Impedance
600 ohms ± 30% @ 1,000 Hz (Balanced)
Operating voltage
9 to 52 volts DC Phantom
Maximum SPL
130 dB
Signal-to-Noise Ratio
40 dB @ 1kHz
Connector
3-pin Male XLR
Windscreen
Black Urethane Foam
Dimensions (HW)
25" x 0.5" (58.42 x 2.54 cm)
Weight
6.5 oz (0.18 kg)
7