Anchor AF-1502 Manual de configuração rápida - Página 7

Procurar online ou descarregar pdf Manual de configuração rápida para Sistemas de filtragem de água Anchor AF-1502. Anchor AF-1502 11 páginas.

3. Install the Filter

Install shut-off valve at the exposed ends of the supply line.

Remove the blue housings from the mounting bracket to install

bracket on the wall. Do not unscrew the black lids of housing from

the bracket. Use the supplied wrench if needed.

Adaptors may be needed on either side of the filter in order to join

the pipe size and type in the house. The filter inlet/outlet fitting is

1 inch.

After the fittings are done, put the housings with the cartridges

back in the brackets.

4. Restart Water Flow

Once all the pipes and connections are complete the system is

ready to be turned on. Turn the main water valve back on slowly.

Sound of water entering the Whole House Filtration System can be

heard.

Important Operating Notes

After the unit is installed, it is necessary to flush the unit thoroughly.

Do this at the nearest water faucet (such as a utility sink or outdoor

faucet). The water will be blackish in color for some time - this is

normal carbon dust. Continue to run water until it runs clear. Shut the

water off and let the unit sit for a while, then flush it again.

An initial "cloudy" appearance to the water may be noticed for a day

or so - this cloudiness is due to tiny air bubbles being purged from the

carbon. This is normal, harmless, and will clear up in a day or two.

After an extended period of inactivity, allow water to run through the

filter for several minutes before drinking.

Maximum recommended flow rate is 15 gallons per minute. Operating

at higher flow rates will not necessarily damage the unit but will

reduce the contaminant removal efficiency.