Carlsbro SLAMMER 2 Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Subwoofer Carlsbro SLAMMER 2. Carlsbro SLAMMER 2 4 páginas.
Imprimir páginaSTORAGE AND TRANSPORTATION
Always store Your Slammer II on a flat surface away from any sources of
moisture. When used for an installation, Carlsbro recommend the use of the
included tamper panel to stop undesired alteration to the set up of your
Slammer II.
TROUBLE SHOOTING
Problem
Possible Cause
No sound
Power switch off
(Mains switch not illuminated)
Faulty Power lead
Blown Mains Fuse
No Sound (mains switch illuminated)
No signal connected
Sound source too low
Damaged cable
Output level set too low
Output is distorted
Output level too high
illuminates
Input signal too strong
Damaged input cables
Limit lights stay on
Level control set too high
Small amount off Bass
Cross-over frequency too low
Subwoofer level set too low
Subwoofer and satellite speakers
Are out of phase
Satellite cabinets' sound undefined
Too much Bass through
satellite speakers
Sound does not project
Satellite speakers are too low
to back of room
insufficient output
lights
Solution
Turn unit on
Replace Lead
Replace fuse with same type and
rating
Insert signal
Increase level of audio source
Replace signal cable
Increase level control
decrease level until limit light
intermittently
Reduce level of input signal
Replace cables
Reduce corresponding level control
Increase cross-over frequency
Increase Subwoofer level
Press Phase switch
Press 120Hz Low Cut switch in
Increase height of satellite cabinets
Increase level controls until limit
INTRODUCTION
Thank you for buying The SLAMMER II active subwoofer. Correctly used
it will provide years of reliable service and fulfill all you performance needs.
Please read this user guide thoroughly in order to safeguard your
equipment and to obtain maximum performance from it.
UNPACKING AND INSPECTION
Carefully unpack the unit. If it appears damaged in any way, return it to
the retailer it was purchased from in its original packaging. Carlsbro
Electronics Ltd cannot accept any responsibility for damage arising from
the use of non-approved packaging.
SYSTEM CONTENTS
•
Slammer II
•
AC Power Lead
•
Manual
•
Guarantee Card
•
Tamper Panel
MAIN FEATURES:
•
Balanced XLR/jack inputs
•
Unbalanced jack/phono inputs
•
Balanced XLR link outputs
•
Independent subwoofer and satellite level controls
•
Independent left, right and subwoofer limiters
•
Active sub-bass filter
•
Switchable active 120Hz low cut on Satellite outputs
•
Variable subwoofer cross-over from 80Hz to 220Hz
•
Subwoofer phase invert switch
•
Recessed control panel with tamper cover
•
600W RMS Power output (300W Subwoofer and 2 x 150W outputs)
•
2 x 10" Kevlar reinforced Powertone™ Loudspeakers
•
Forced air cooling
•
Custom punched metal grille
•
Non-slip rubber feet
•
Integrated handles