Electrolux EIDW1805KS0A Manual de instruções de instalação - Página 5
Procurar online ou descarregar pdf Manual de instruções de instalação para Máquina de lavar loiça Electrolux EIDW1805KS0A. Electrolux EIDW1805KS0A 13 páginas. Built-in dishwasher
Também para Electrolux EIDW1805KS0A: Manual de utilização e cuidados (17 páginas)
Imprimir página
Installation Instructions
PREPARE HOT WATER LINE
• The line may enter from either side, rear or floor
within the shaded
area shown in Figure R
• The line may pass throughthe
same hole as the
electrical
cable and drain hose. Or, cut an
additional
1-1/2" dia. hole to accommodate
the
water line.
If power cord with plug is used, water line must
not pass through
power cord hole.
Figure F
Water Line Connection
• Turn off the water supply.
• Install a hand shut-off
valve in an accessible
location,
such as under the sink.
(Optional,
but
strongly
recommended
and may be required
by
local codes.)
• Water connection
is on the left side of the
dishwasher.
Install the hot water inlet line, using
no less than 3/8" O.D. copper tubing.
Route the
line as shown in Figure
F and extend forward at
least 18" from rear wall.
• Adjust water heater for 120 °F to 150 °F tem-
perature..
• Flush water line to clean out debris.
• The hot water supply line pressure
must be 20-
120PSI.
CAUTION :
Opening the door will
cause the dishwasher
to tip forward.
Do not open
the door until you are ready to
install the dishwasher.
If it is
necessary to open the
door,
hold the
top
of the dishwasehr
securely
with
one hand and hold the door with the
other hand.
BEFORE YOU BEGIN
Locate and set aside the package
containing
2 Phillips head countertop
mouting
screws and 2 additional
toekick
screw (located
in the literature
pack).
STEP 1
CHECK DOOR BALANCE
To check the door balance,
hold the top of the
dishwasher
firmly.
_n
ior
les,
test
I
balanced.