Electrolux Energy Star WT65H240DU Manual de instruções - Página 15
Procurar online ou descarregar pdf Manual de instruções para Máquina de lavar loiça Electrolux Energy Star WT65H240DU. Electrolux Energy Star WT65H240DU 18 páginas. Electrolux dishwasher instruction manual
Também para Electrolux Energy Star WT65H240DU: Ficha de especificações (3 páginas)
Imprimir página
or scrapers; rinse thoroughly using a wet cloth and care-
fully wipe dry. Clean the control panel using a soft damp
cloth and a neutral detergent if necessary.
Do not wash the appliance using direct or high-pressure
water jets. To reduce the emission of pollutants into the
environment, clean the appliance (externally and where
necessary internally) with products having a biodegrada-
bility of over 90%.
Leave the hood raised whenever the appliance is not in
use.
D5
MAINTENANCE
DELIMING
WARNING: DELIMING SOLUTION, RINSE AGENTS
OR ANY OTHER KIND OF ACID MUST NOT COME IN
CONTACT WITH BLEACH OR RINSE SOLUTION
CONTAINING BLEACH USED IN CHEMICAL-SANITI-
ZING MACHINES. MIXING MAY CAUSE HAZARDOUS
GAS TO FORM. THIS ENTIRE PROCEDURE MUST
BE FOLLOWED STEP BY STEP FOR SAFE AND SATI-
SFACTORY RESULTS.
DELIME THE DISHWASHER ON A REGULAR BASIS
AS REQUIRED. The regurarity will depend on mineral
content of the supply water. Deliming should be done
when you can see clear signs of lime deposits (a white,
chalky substance) on the inside walls and on the wash
arms. If deliming is necessary, a deliming agent should
be used for best results.
Step 1 - Discarge tank dirty water
Raise the hood and remove any baskets that are in
chamber.
Remove tank filter "C" and overflow "W".
W
Close the hood and select the drain cycle by pressing
the "B" button (Figure 13).
The message "CLE" ("CLEAN") will be displayed throu-
ghout the drain cycle.
C
After a few minutes, 3 beeps indicate the end of the cle-
aning cycle and "END" blinks on the display:
At the end of drain cycle, raise the hood, replace the
tank filter "C", the overflow "W" and close the hood.
Switch off the dishwasher by pressing "A" button
(Figure 13)
Step 2 - Filling tank and heating water
Press on/off "A" button (Figure 13).
The indicator light of the on/off button "A" comes on, indi-
cating the dishwasher is powered and the water is being
introduced and heated. The word "FILL" scrolls across
display during the entire filling and heating stage.
The filling and heating stage has finished when the
display shows the tank temperature:
Step 3 - Pour the deliming agent
Raise the hood, pour the required amount of deliming
agent regarding agent concentration suggested by agent
supplier for 11 gallons/42 liters of water.
Step 4 - Start the wash cycle and discarge the tank
Close the hood and start the Cycle III by pressing "F"
button (Figure 13). The wash cycle duration is 2 minu-
tes.
3
At the end of the cycle the dishwasher emits a series of
beeps and "END" blinks on the display.
CAUTION: observe chemicals producers instruc-
tions handling appliance where chemicals have
been used.
17