Electrolux ESF 67060 Manual do utilizador - Página 14
Procurar online ou descarregar pdf Manual do utilizador para Máquina de lavar loiça Electrolux ESF 67060. Electrolux ESF 67060 20 páginas.
Imprimir página14 electrolux
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the
dishes.
There are streaks, milky stains,
or a bluish layer on glasses and
dishes.
Dry water drop stains on
glasses and dishes.
The dishes are wet.
The dishes are wet and dull.
How to activate the rinse aid dispenser
1. Switch on the appliance.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold function buttons B and C.
– The programme indicator lights above
function buttons A, B, and C start to
flash.
4. Release function buttons B and C.
5. Press function button B.
– The programme indicator lights above
function buttons A and C go off.
Possible cause
The selected washing pro-
gramme was not applicable for
the type of load and soil.
The baskets were not loaded
correctly, water did not touch
all surfaces.
The spray arms could not turn
freely because of incorrect ar-
rangement of the load.
The filters are dirty or not as-
sembled and installed correctly.
The quantity of detergent was
not sufficient or missing.
The salt container is empty.
Incorrect water softener adjust-
ment
The salt container cap is not
closed correctly.
Rinse aid dosage is too high.
Rinse aid dosage is too low.
The detergent can be the cause. Use a different brand of deter-
You have set a washing pro-
gramme without drying phase
or with a decreased drying
phase.
The rinse aid dispenser is emp-
ty.
The multitab function is on (this
function automatically deacti-
vates the rinse aid dispenser).
6. Press function button B again.
Possible solution
Make sure that the washing pro-
gramme is applicable for the
type of load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are
clean and correctly assembled
and installed.
Make sure that the quantity of
detergent is sufficient.
Fill the salt container with dish-
washer salt.
Adjust the water softener.
Make sure that the salt contain-
er cap is closed correctly.
Decrease the rinse aid dosage.
Increase the rinse aid dosage.
gent.
Let the door stay ajar for some
minutes before you remove the
dishes.
Fill the rinse aid dispenser with
rinse aid.
Activate the rinse aid dispense.
– The programme indicator light above
function button B continues to flash.
– The display shows the current set.
Rinse aid dispenser de-
activated
Rinse aid dispenser ac-
tivated
– The display shows the new adjust-
ment.