Forms+Surfaces Aptos Pedestrian Instruções de instalação/ligação - Página 2

Procurar online ou descarregar pdf Instruções de instalação/ligação para Luz exterior Forms+Surfaces Aptos Pedestrian. Forms+Surfaces Aptos Pedestrian 5 páginas. Surface mount

Imprimir página

APTOS

PEDESTRIAN

™

STEP BY STEP

FOR ALL APTOS PEDESTRIAN LIGHTING

Locate wires

Note: Installation should be performed only

by qualified individuals.

• Before proceeding with wiring of fixture,

check to ensure that all applicable site

wiring and safety codes have been

followed.

• Remove two screws on access door at

base of light pole with 1/8" security hex

bit, and remove access door.

• Locate wires at base of light fixture.

Ensure power supply is shut off and circuit

being used is isolated.

Caution: Installation of a surge

protector as part of each unit's wiring

is recommended.

T 800.451.0410 | www.forms-surfaces.com

© 2020 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.

11-13mm

(0.47in.)

Prepare wires

• Prepare wiring from site junction box and

bollard by stripping and removing 11-

13mm (.47") of insulation.

Note: Wire used should be 22-14 AWG

copper conductors.

SURFACE MOUNT INSTALLATION & WIRING INSTRUCTIONS

Connect wires

• Insert ground (green), neutral (white), and

positive (black) wires into provided wire

nuts, being sure to match wire color codes

from junction box to fixture.

• Tighten wire nuts until exposed wire ends

are below bottom of wire nut.

• Inspect all wiring and connections before

turning power supply on.

Caution: Light fixture rated for 120-277

VAC power.

page 2 of 5 | 12-08-20