Dreamer DC-IH01 Manual do utilizador - Página 4

Procurar online ou descarregar pdf Manual do utilizador para Placa de fogão Dreamer DC-IH01. Dreamer DC-IH01 4 páginas. Ih cooktop

6. Residual heat display

After turn off the cooktop, the LED screen will show "H", it will disappear until the glass

plate temperature lower than 60℃

7. When in cooking mode, the cooktop will be automatic switched off after 2 hours if

without other operate

TYPES OF UTENSILS THAT CAN BE USED

Steel, cast iron, enameled iron, stainless steel, flat-bottom pans/pots with diameter from 12 to 26cm.

CLEANING & MAINTENANCE

1) Disconnect plug and wait until the unit is cooled down completely. Clean after using every time.

2) If the pots/pans are used without being cleaned, discoloration or cooked on stains may be caused.

3) Do not use benzine, thinner, scrubbing brush or polishing powder to clean the IH cooktop.

4) Wipe using dish washing agent and damp cloth.

5) Use vacuum cleaner to suck up dirt from the air intake and exhaust vent.

6) Never run water over the unit (Water gets inside may cause malfunction).

FAULT ANALYSIS for induction cooktop

E0: Check whether there is no pot or the pot is not acceptable.

E1: Check whether the Voltage is too low, lower than 88V.

E2: Check whether the Voltage is too high, higher than 280V.

E3: Check whether glass plate heat sensor is over heat or short circuit.

E4: Check whether glass plate heat sensor is open circuit.

E5: Check whether IGBT sensor is over heat or short circuit.

E6: Check whether IGBT sensor open circuit or broken.

E8: When the liquid spills out of the pot, and it cover 3 or more than 3 function keys of the

control panel, the LED screen will show E8.

Turn off the cooktop and clean up the liquid on the control panel, the cooktop can be restored

to normal operation

Dreamer Customer Care Center

No. 160, Nam Ki Khoi Nghia St., Ward 6, Dist. 3,

Ho Chi Minh City, Vietnam

Tel: +84 961 298 399