ANDELI MCT-520DPL Manual do Proprietário - Página 9
Procurar online ou descarregar pdf Manual do Proprietário para Sistema de soldadura ANDELI MCT-520DPL. ANDELI MCT-520DPL 20 páginas. Multifuction welding&cutting machine
Também para ANDELI MCT-520DPL: Manual do Proprietário (8 páginas)
Welding Set Up & Operation
5.5
NOTE:
Please connect the power line of the welder to the
on the machine nameplate.
5
.5.1Welding wire reel installation
Warning!
mains power is switched off
Warning!
premature wear of the drive roller, the support bearing and the drive motor.
- Before changing the feed roller or wire spool, ensure that the
- The use of excessive feed tension will cause rapid and
input voltage consistent with the parameters
Loose
the
knob,install the wire reel on the holder
of wire feeding machine, the hole of
wire reel should align with fixed pin on
the holder.
Loose tensioner arm,choose different
wire feeding groove according to the
wire
dimension.
welding chooses U-shape groove, other
welding
wire
groove)
Loose the nut of wire pressing roller,
thread the welding wire from the spool
through the wire input guide tube,
through the roller groove and into the
outlet guide tube. Note: adjust the
tensioner and impact the wire, to make
sure the wire will not slide. Avoid the
wire deformation due to the oversize
pressure.
Release the wire by rotating the wire
reel anticlockwise. In order to avoid
wire loose, the new wire reel will fix the
top of wire on the edge of wire reel.
Please cut off this top of wire.
choose different wire feeding groove
position according to the wire diameter.
Press the "Wire Check" button on the
panel, let the wire out of the nozzle.
8
wire
spool
retaining
(Note:
aluminum
choose
the
V-shape