Dreaming Robots Electric Eel Wheel 6.0 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Robótica Dreaming Robots Electric Eel Wheel 6.0. Dreaming Robots Electric Eel Wheel 6.0 12 páginas.
Imprimir página
Initial Setup
When you receive the EEW, you need to spend a few minutes
putting together some parts. No tools are required for this
assembly.
First, assemble the bobbins. There are two types of bobbin disks
one has a pulley (extra ridges) and the other is flat. Put a metal
bearing into the end of each type of bobbin disk. Then take each of
those disks and screw them onto a bobbin tube.
Next, slide a bobbin onto the flyer with the flat end at the orifice
and the pulley end at the back. Put a metal bearing onto the back of
the flyer and slot the whole flyer assembly into the base.
Finally, put the black drive belt on the motor pulley, and then wrap
it around the flyer in the drive belt groove. Slide the tension string
into the bobbin pulley. When you start spinning, you can adjust the
tension dial; see the "Adjusting Uptake" section below.
If you want to attach the bottom cover (optional), slide its screws
into the slots in the base. The bottom cover can hold a battery so
you can spin without plugging the EEW into a wall outlet. Check
www.dreamingrobots.com/eew-60
for more information about
battery packs that work well with the EEW.
3