ATI Technologies SR-82 Manual de substituição - Página 8
Procurar online ou descarregar pdf Manual de substituição para Acessórios ATI Technologies SR-82. ATI Technologies SR-82 10 páginas. Robotic collision sensor switch
Imprimir páginaManual, Collision Sensor Switch Replacement, SR‑82
Document #9610‑60‑1017‑03
1.5 Switch Adjustment
There are (2) styles of switch/connector block assemblies for the SR‑82 Collision Sensor. The original style
has a larger connector body than the current style. The current style has an adjustment set screw in the side
of the connector body, refer to
Figure 1.4—Determine the Switch/Connector Block Assemblies Style
If adjusting an original style switch, it is necessary to return the unit to ATI for servicing.
If adjusting a current style switch, refer to
1.5.1 Current Style Switch Adjustment
Note: The switch is factory adjusted to open after the stem has traveled .025" in the axial direction.
Adjustments should only be made if replacing the switch.
1. De‑energize all electrical and pneumatic power supplied to the Collision Sensor. Drain all stored
air and electric power in compliance with standard (OSHA) safety practices and standards.
2. Disconnect the air lines and signal wires connected to the Collision Sensor.
Pinnacle Park • 1031 Goodworth Drive • Apex, NC 27539 USA • Tel: 919.772.0115 • Fax: 919.772.8259 • www.ati‑ia.com
Figure 1.6.
Section 1.5.1—Current Style Switch Adjustment
8