Andersen 52ST Manual - Página 5

Procurar online ou descarregar pdf Manual para Guinchos Andersen 52ST. Andersen 52ST 9 páginas.
Também para Andersen 52ST: Manual (6 páginas)

Tools required for service.

Allen key (4 mm)

Allen key (5 mm)

Screwdriver (large).

Screwdriver (small).

Winch handle.

ANDERSEN winch grease

Remove screws (1).

Remove self-tailing arm (2) and drum (5).

Remove drive shaft (6)

Clean the balls (8, 9) with a rag. DO NOT remove the balls and the small retaining ring (7)

above the balls.

Remove screws (10).

Remove upper base (13).

Remove roller bearing (12).

Remove screw (15), shaft (19) and gear wheel (20).

Remove shafts (16)

10.

Remove and dismantle the two gear units (17, 18).

11.

Clean all parts in benzine. Remember to clean the gear teeth, roller bearing track and all

ball tracks inside the drum (5).

12.

Assemble in reverse order. During assembly, by the use of a small soft brush lightly grease

all gear teeth, drive shaft, roller bearing, shafts, balls, pawls, springs and composite

bushings. Pawls should only be lubricated with a very thin film of ANDERSEN WINCH

GREASE. It is very important that pawls can move freely.

IMPORTANT: When assembling the winch, check the function of each pawl by pushing the pawl

against the spring. The pawls should smoothly and automatically return to their normal position,

where the pawls engage with the teeth. If the pawls do not function correctly, clean and lightly

lubricate the pawls and gears again and replace the springs where necessary.

Malfunctioning pawls may lead to unexpected failure of a loaded winch resulting in material

damage or fatal personal injury.

Service Kit No 8. (art. No. 710008) contains spare parts for this winch.

www.Busse-Yachtshop.de - [email protected]

SERVICE INSTRUCTION

52ST ver. 2.5 – 52ST FS ver. 2.5

For current World Wide Distributor list please see: