Andersen SmoothControl+ Left Hand Hydraulic Closer Manual de instalação - Página 2
Procurar online ou descarregar pdf Manual de instalação para Sistema de abertura de portas Andersen SmoothControl+ Left Hand Hydraulic Closer. Andersen SmoothControl+ Left Hand Hydraulic Closer 4 páginas. Replacement for andersen 1-1/2” fullview storm doors
REMOVE HYDRAULIC
1
CLOSER AND INSTALL
REPLACEMENT PART
(Left Hand)
a
1.
With the door seated in the open position look for the hole in the top
of the hydraulic closer unit on top of the door frame. Insert the locking
pin found in the pink hardware bag into the hydraulic closer hole.
c
1.
From the interior side of the door, loosen the hydraulic closer arm
connecting bolt on the under-side of the rain cap damper assembly
using the hex wrench provided in the pink hardware bag.
NOTE: The connecting bolt is secured to the closer arm.
2.
Once the connecting bolt is completely loose, pull down
slightly on the closer arm and swing the door out of the way.
Hex Wrench
(provided)
LOCKING
PIN
HYDRAULIC
CLOSER HOLE
1.
1.
2.
2
Tools recommended:
Screwdrivers
!
!
b
5/8"
5/8"
5/8"
5/8"
1 1/2"
Close the door until the closer arm is resting against the locking pin
1 1/2"
which will keep the door from closing fully.
1 1/2"
1 1/2"
d
Remove the locking pin from the top of the hydraulic closer unit by
pulling the closer arm slightly away from the door frame and lifting
locking pin from closer hole. Then carefully let the closer arm swing
back to its neutral position over the closer.
Using a Phillips screwdriver, remove the two unpainted screws from
the top of the hydraulic closer unit and properly dispose of the screws.
IMPORTANT
If you have a fixed laminated glass 3-point lock door, go to the
steps on page 4 of this guide after completion of this step (Step D).
CLEAR HARDWARE BAG
Unpainted Flat
Head Screws
(Qty 2)
!
!
LOCKING
PIN
1/2"
1/2"
2"
2"