Bosch Instructions for Use Manual de instruções de instalação e utilização - Página 5

Imprimir página

Bosch Instructions for Use Manual de instruções de instalação e utilização

1. What to Do if

Information on laundry ...

Labelling of fabrics

Follow the manufacturer's care information.

Drying at normal temperature.

Drying at low temperature

also select Low Heat .

Do not machine dry.

Observe safety instructions without fail

Do not tumble-dry the following fabrics for example:

– Impermeable fabrics (e.g. rubber-coated fabrics).

– Delicate materials (silk or curtains made from synthetic material)

– Laundry contaminated with oil.

Drying tips

– To ensure a consistent result, sort the laundry by fabric type and drying programme.

– Always dry very small items (e.g. baby socks) together with large items of laundry (e.g. hand

towel).

– Close zips, hooks and eyelets, and button up covers.

Tie fabric belts, apron strings, etc. together

– Do not over-dry easy-care laundry

Allow laundry to finish drying in the air.

– Do not dry woolens in the dryer, only use to freshen them up

Programme (depending on model).

– Do not iron laundry immediately after drying, fold items up and leave for a while

remaining moisture will then be distributed evenly.

– Machine-knitted fabrics (e.g. T-shirts or jerseys) often shrink the first time they are dried

do not use the Extra Dry programme.

– Starched laundry is not always suitable for dryers

adversely affects the drying operation.

– Use the correct dosage of fabric softener as per the manufacturer's instructions when

washing the laundry to be dried.

– Use the timer programme for small loads

Environmental protection/energy-saving tips

– Before drying, spin the laundry thoroughly in the washing machine

speed the shorter the drying time will be (consumes less energy), also spin easy-care

laundry.

– Put in, but do not exceed, the maximum recommended quantity of laundry

programme overview

Page 7.

– Make sure the room is well ventilated during drying.

– Do not obstruct or seal up the air inlet.

– Keep the air cooler clean

page 6 "Care and cleaning".

Page 11!

they may crease

risk of creasing!

Page 7, Woollens finish

starch leaves behind a coating that

this improves the drying result.

the higher the spin

Care and cleaning

Dryer housing, control panel, air cooler, moisture sensors

– Wipe with a soft, damp cloth.

– Do not use harsh cleaning agents and solvents.

– Remove detergent and cleaning agent residue immediately.

Air cooler

– Allow the dryer to cool.

– Residual water may leak out, so place an absorbent towel

underneath the maintenance door.

1. Unlock the maintenance door.

2. Open the maintenance door fully.

3. Turn both locking levers towards each another.

4. Pull out the air cooler.

Do not damage the air cooler.

the

Clean with warm water only. Do not use any hard or sharp-edged

objects.

5. Clean the air cooler thoroughly,

Allow to drip dry.

6. Clean the seals.

7. Re-insert the air cooler,

with the handle facing down.

8. Turn back both locking levers.

9. Close the maintenance door until the lock clicks into place.

Moisture sensors

The dryer is fitted with stainless steel moisture sensors. The sensors

measure the level of moisture in the laundry. After a long period of

operation, a fine layer of limescale may form on the sensors.

1. Open the door and clean the moisture sensors with a damp sponge

which has a rough surface.

Do not use steel wool or abrasive materials.

Only when switched off!

Clean the air cooler 5 - 6 times a year

or if Clean flashes after cleaning the fluff filter.