CARNES HXHAF Manual do proprietário e manual de referência - Página 5

Procurar online ou descarregar pdf Manual do proprietário e manual de referência para Humedecer CARNES HXHAF. CARNES HXHAF 20 páginas.

Humidistat Option 1 — Return Duct

1. Choose a location on the return air

duct to mount the duct sensor. See

Figure 2 for location options. Make

sure

location is close enough to plug in

the sensor. Install the sensor a

minimum 6 inches ahead of or a

minimum 15 inches after a

change in airflow direction or

obstruction in the duct. Do not

install duct sensor near outdoor

air intake.

2. Drill a ½ inch hole in the duct to

place the sensor. Use a sheet metal

screw (D) to attach sensor to the

duct. Arrows in duct mount sensor indicate the direction the airflow

should pass over the sensor for optimal readings (Figure 1).

3. Mount the humidistat to a wall or duct in a convenient location that

allows easy adjustment to the settings. To mount the humidistat,

remove the back plate and install with screws (D or E) through the

mounting holes.

4. Plug the duct sensor into the humidistat. Pay close attention to the

orientation of the plug or permanent damage will occur to the

sensor. See Figure 3 for proper orientation of the duct sensor plug.

Place the hook of the red plug up away from the circuit board and push

onto the white connector in the bottom left corner. The wire colors are

also marked on the circuit board and match the correct orientation of

the plug wires.

Form 16763

RESIDENTIAL HUMIDISTAT

the

humidistat

mounting

Figure 1: Duct Sensor

Installation

Airflow