9. Replace the coveronthe
terminal b lockandfastenin
place.
[-_
Make sure that the U.L strain
relief clamp is outside the
cover!
The appliance
is now ready to be
plugged into the 4-wire receptacle
of the power rating.
Connecting
3-wire
power
supply
cord
1. Remove the screws from the
cover of the terminal block
located at the top rear of the
appliance.
2. Unscrew the 2 screws labeled
L and the screw labeled N in
the terminal block and the
grounding
screw - green
colored.
3. Loosen the U.L. stain relief and
remove the 4-wire
power cord.
4. Save the grounding
screw -
green colored.
5. With the 3-wire
cord, attach
the 2 power cord outer
conductors
(red and black) to
the 2 terminals
labeled L and
the remaining
power cord
conductor
(white) to the
housing
ground using the
green ground screw as shown.
6. Tighten back all 3 screws (3
Nm) so that the power
conductors
are held in place
securely.
7. Check the U.L strain relief
clamp to make sure that it is
tight and cannot be turned.
8. Replace the cover on the
terminal
block and fasten in
place.
Integrated
socket
This appliance
is equipped
with
a socket for connecting
a washer
without fuses or circuit breaker.
Only the listed washer may be
connected.
For all other
connections
Bosch will assume no
liability.
Use copper
conducters
only.
Connect
to a 30 A minimum
individual branch circuit, fused at
30 A maximum.
Use receptable
only for:
208-240
VAC 60 Hz 11 A
washer:
WFR2460UC,
WFL2060UC,
WAE20060UC,
WAS20160UC,
WAS24460UC.
Condensate
hose
connection
The dryer must have its condensate
drain line installed and run to
a suitable drain.
The connection
for the condensate
hose is located on the back of the
dryer.
Connect
the condensate
drain hose
to the dryer. The other end should
then be placed and secured at
nearby sink or drain.
If installed with a washer it may,
room permitting,
be installed next to
the washer drain hose and drained
to the same drain used by the
washer.
Be sure to follow all local codes
and regulations
in running the
condensate
to a suitable drain.
9