Bosch Nexxt Premium WTMC6300 Manual de instruções de funcionamento, cuidados e instalação - Página 8
Procurar online ou descarregar pdf Manual de instruções de funcionamento, cuidados e instalação para Secador Bosch Nexxt Premium WTMC6300. Bosch Nexxt Premium WTMC6300 28 páginas.
Imprimir página
Electrical
connection
Power cord must be connected
by a qualified person only.
Connect
to individual
Brunch
Circuit,
Do not use an adapter.
Do not use an extension
cord.
Do not remove ground prong.
For CANADA
Your dryer comes with a power
supply cord, CSA listed in Canada.
The Bosch dryer requires a 4 wire
receptacle.
When installing the receptacle
for
the dryer cord, ensure that the
power supply cord is accessible
when the dryer is in the installed
position.
The power cord should only be
replaced
by a qualified person.
Use a 4 wire power supply cord
(see electrical connection
U.S.A.
below).
For U.S.A.
Your dryer comes without a power
supply cord. The power cord must
meet the following
requirements:
UL listed in the USA
Power cord must be connected
by a licensed electrician
only.
Use only a U.L. approved
30 amp power cord with strain
relief clamp
note manufacturer's
instructions.
Do not plug end of power cord
into a live receptacle
before con-
necting power cord to appliance
terminals
and closing junction/
splitter box as described
below.
Do not reuse old power cord.
Cord must have closed loop or
upturned
end wire terminating
connectors.
Do not make a sharp bend or
crimp wiring/conductor
at con
nections.
Only a 4 conductor
cord shall
be used when the appliance
is
installed in a mobile home or an
area where the local codes do
not permit grounding
through
the neutral.
Connecting
4-wire
power
supply
cord
1. Remove the screws from the
cover of the terminal block
located at the top rear of the
appliance.
Et
1
2
3
3. Fix the strain relief clamp to the
angle bracket, Tighten the nut,
4. Loosen the 2 screws labeled L
and the screw labeled N in the
terminal block, and the screw
of the GROUND terminal.
5. Thread the 4 wire cable through
the U.L. strain relief clamp.
6. Tighten the screws (2.5 Nm) of
the U.L. strain relief clamp so
that the power cord cannot be
moved.
7. Attach the power cord ground
conductor
(green) to the
GROUND terminal.
Tighten the
screw (2.5 Nm) so that the
ground conductor
is held
securely in place.
8. Attach the 2 power cord outer
conductors
(red and black) to
the 2 terminals
labeled L and
the remaining power cord
conductor
(white) to the
terminal labeled N.
9. Tighten all 3 screws (3 Nm) so
that the power conductors
are
held securely in place.
208
240 volt rated (minimum)
30 amps
Type SRDT or DRT (UL 2158)
Five feet tong (minimum)
1 -
terminalblock
2-
groundingstrap
3 -
Anglebracketfor strain reliefclamp
2. Loosen the bottom
screw of
the grounding
strap. Place the
screw to the GROUND
location.
Planish the grounding
strap and hang loosely.
8