Installation
Care and cleaning
Heat exchanger
– Scope of delivery: dryer, installation and operating instructions.
The dryer's heat exchanger is cleaned automatically during drying. Cln appears in the display
– Check dryer for transport damage.
panel. Do not pull out the condensation container during the cleaning process.
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
Dryer housing, control panel, air intake
– Do not set up in a room that is susceptible to frost. Freezing water may cause damage.
Wipe with a soft, damp cloth.
– If in doubt, have the appliance connected by a specialist.
Do not use harsh cleaning agents or solvents.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Remove detergent and cleaning agent residue immediately.
Some water may collect between the window and the seal during drying. This does not affect
Setting up the dryer
Take all accessory parts out
1.
the proper operation of your dryer in any way.
of the drum.
– The appliance plug must always be accessible.
The drum must be empty.
Filter in the condensation container
– Ensure that the appliance is installed on a clean, level
and firm surface.
The filter is cleaned automatically when the condensation container is emptied.
– Do not obstruct the air inlet on the front of the
However, the filter should still be cleaned regularly under running water
dryer.
stubborn deposits/dirt from building up.
– Keep the area around the dryer clean.
– Make the dryer level using the threaded feet
and a spirit level.
1. Pull out the condensation container.
– Do not remove the threaded feet under any
circumstances.
2. Pull the filter out of its snap-in lock.
Do not set up the dryer behind a door or sliding
door, as this may obstruct the dryer door or prevent
it from opening. This will prevent a potentially fatal
danger to children from locking themselves in.
Clean and level
Make sure that the air inlet
remains unobstructed
3. Clean the filter under running water or in the dishwasher.
2.
Mains connection
see Safety instructions
page 13.
– Connect to an AC earthed socket. If in doubt have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (
page 10) must be the
same.
– The connected load and necessary fuse protection are specified on the rating plate.
Frost protection
Do not operate the dryer if
4. Refit the filter.
there is a danger of frost.
Preparation
5. Insert the condensation container so that it locks into place.
1. Empty the condensation container
page 4.
2. Select any programme using the programme selector.
Only operate the dryer with the filter inserted.
3. Press the
Start/ Stop button
condensed water is pumped into the container
4. Wait 5 minutes and then empty the condensation container again.
Moisture sensor
5. Turn the programme selector to Off .
The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure how
Transport
damp the laundry is. A thin layer of limescale may build up on the moisture sensors after
prolonged use.
1. Open the door.
– Prepare the dryer
see Frost protection.
2. Clean the moisture sensors using a damp sponge with a rough surface.
– Transport the dryer in a vertical upright position.
– Following transportation, do not use the dryer for two hours.
Do not use steel wool or abrasive materials.
The dryer contains residual water;
this can flow out if the dryer is tilted.
8
Appliance must be switched off.
Technical data
Dimensions (DxWxH)
60 x 60 x 85 cm (height adjustable)
Weight
approximately 51 kg
Max. capacity
7 kg
Condensation container
4.0 l
Connection voltage
220-240 V
Connected load
max. 1000 W
Fuse protection
10 A
Ambient temperature
5 - 35 °C
Product number
under the door
Production number
This prevents
The rating plate can be found on the back of the dryer.
Consumption rates
These are guide values determined under standard
conditions.
Spin speed
Drying time
Energy
in rpm
in min.**
consumption
(residual moisture)
in kWh**
Cottons 7 kg
Cupboard Dry*
1400 (approx. 50 %)
128
1.62
1000 (approx. 60 %)
149
1.90
800 (approx. 70 %)
169
2.19
Iron Dry*
1400 (approx. 50 %)
92
1.13
1000 (approx. 60 %)
113
1.42
800 (approx. 70 %)
133
1.70
Easy-Care 3.5 kg
Cupboard Dry*
800 (approx. 40 %)
54
0.57
600 (approx. 50 %)
68
0.72
*Test programs according to DIN EN 61121
**The values may differ from those given, depending on overvoltage and undervoltage, the
type of fabric, composition of the laundry to be dried, the residual moisture in the fabric and
the size of the load.
Drum interior light
(depending on model)
(bulb E14, 25 W)
The drum lights up after the door is opened or closed, and after the programme starts, and
switches off automatically. Changing the bulb
page 12.
Optional accessories
(from after-sales service using order number)
Washer-dryer stack connection set
WTZ
11310
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened to the washing machine using this connection set.
WTZ
Same as WTZ 11310, but with pull-out worktop.
11300
Installation underneath the worktop
WTZ
10290
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
9
Normal noises
What to do if...
If you cannot rectify a fault yourself (e.g. switching off/on), please contact our after-sales
During drying, the compressor and the pump generate some noise which is entirely normal.
service. We will always find an appropriate solution and will avoid unnecessary visits by
engineers. Trust the expertise of the manufacturer and rest assured that the repair will be
carried out by trained service technicians using original spare parts. The contact details of your
local after-sales service can be found in the enclosed after-sales service directory, or by calling
one of these numbers:
– GB 0844 8928979 (Calls from a BT landline will be charged at up to 3 pence per minute.
A call set-up fee of up to 6 pence may apply.)
The compressor in the dryer may
– IE 01450 2655
occasionally generate a humming noise.
When contacting the after-sales service, please quote the appliance's product number (E no.)
and production number (FD) (see under the loading door).
Turn the programme selector to Off and unplug the mains plug from the socket.
The
Start/Stop indicator lamp
does not light up.
The Container indicator lamp
and the
Start/Stop button are
flashing.
The Filter indicator lamp and
Start/Stop button are flashing.
Cln appears in the display panel. Not an error. Automatic cleaning of the heat exchanger.
The compressor in the dryer is ventilated
from time to time, which creates a whirring
Dryer does not start.
sound.
Water is leaking out.
The door opens by itself.
Creasing.
Drying result is not satisfactory
(laundry feels too damp).
The automatic cleaning process causes
a clicking noise.
Drying time too long.
The humidity in the room
increases significantly.
Power failure.
The process of pumping the condensation
into the condensation container generates
Other intermittent noises
pumping noises.
and vibrations.
Loud humming noise for several
seconds.
The interior light is not working
(depending on model).
10
11
Safety instructions
Emergency
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
ONLY use the
– in rooms inside the house.
dryer...
– to dry fabrics.
The dryer must
– be used for purposes other than those described above.
NEVER...
– be modified in terms of its technology or properties.
Hazards
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
– Keep pets away from the dryer.
– Remove all objects from pockets,
and lighters in particular
Risk of explosion.
Mains plug plugged in?
– Do not lean or sit on the door
Risk of tipping.
Programme selected?
Installation
– Secure loose cables
Risk of tripping.
Empty the condensation container
page 4.
– Do not operate a dryer if there is a risk of frost.
Clean the condensation container filter if necessary
Mains
– Connect the dryer to an AC earthed socket according to specifications,
page 9.
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
Dryer transported?
Wait 2 hours and start again.
– The cable cross-section must be sufficient.
Rinse the fluff filter under running water
page 4.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/connectors and/or extension cables.
Do not empty the condensation container.
– Do not touch or hold the appliance plug with wet hands
Start/Stop button selected?
Risk of electric shock.
Door closed? Programme set?
– Never pull the appliance plug out of the socket by its cable.
Ambient temperature greater than 5 °C?
– Do not damage the mains lead
Risk of electric shock.
Make sure the dryer is level.
Operation
– Only load the drum with laundry.
Push the door closed until you hear it click into place.
Check the contents before you switch the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
Laundry load exceeded?
grease or paint (e.g. hair styling products, nail varnish remover, stain remover,
Remove articles of clothing immediately after the end of the
cleaning solvent, etc.)
Risk of fire/explosion.
programme, hang up and pull into shape.
– Dust (e.g. coal dust, flour) poses a danger: Do not use the dryer
Unsuitable programme selected
page 7.
Risk of explosion
Warm laundry feels damper than it actually is.
– Do not put laundry containing foamed material/rubber in the dryer
The selected programme does not suit the load. Use
material may be destroyed and the dryer be damaged due to possible
another drying programme or, in addition, select the time
deformation of the foamed material.
programme
page 7.
– When cleaning the fluff filter, make sure that no foreign material (down or filling
Use fine adjustment for the drying result
page 1/2 and 6.
material) gets into the air duct opening. If necessary, clean the drum
Fine layer of limescale on the humidity sensors
beforehand with a vacuum cleaner. If foreign material should still get into the
Clean the humidity sensors
page 9.
air duct
call the after-sales service
Risk of fire/explosion.
Programme termination, e.g. tank full, mains power supply
– Switch off the dryer once the programme has ended.
failure, door open or maximum drying time reached.
– The water from condensation is not drinking water and may be contaminated
Rinse the fluff filters under running water
page 4.
with fluff.
Insufficient supply of air
ensure that air can circulate.
Air inlet possibly blocked
Clear inlet
page 8.
Defect
– Do not use the dryer if it is defective or if you suspect that it is.
Ambient temperature higher than 35 °C
ventilate the
Repairs must only be carried out by the after-sales service.
room.
– Do not use the dryer if the mains cable is defective. To avoid danger, only have
Make sure the room is sufficiently ventilated.
the defective mains cable replaced by the after-sales service.
– Always pull the mains plug out of the socket before changing the bulb for the
Remove laundry from the dryer immediately and spread out.
interior light
Risk of electric shock.
This allows the heat to dissipate.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Not an error.
Disposal
– Pull out the appliance plug, then cut off the mains cable from the appliance.
Normal noises
page 11.
Dispose of at a municipal waste disposal facility.
Has the condensation container been properly inserted?
– Heat exchangers contain a fluorinated greenhouse gas covered by the Kyoto
Push the condensation container all the way in.
protocol (R134a)
dispose of in a proper manner. Capacity: 0.22 kg.
Not an error. Normal noises
page 11.
– Packaging: Keep all packaging out of reach of babies and children
Pull out the appliance plug, remove the cover cap in the
Risk of suffocation.
interior above the door (use Torx 20 screwdriver) and
– All materials are environmentally sound and can be reused. Dispose of in an
replace the bulb
page 10. Close the cover cap.
environmentally-responsible manner.
Never operate the dryer without a cover cap.
12
elastic
Dryer
en Instruction manual
13
Imprimir página