Bosch Series 4 Informações de utilização - Página 17

Imprimir página

Bosch Series 4 Informações de utilização

17.7 Cleaning the overflow container

The overflow container collects liquids or objects that

come into the appliance from above.

Requirement: The appliance has cooled and the resid-

ual heat indicator has gone out.

Hold the overflow container with one hand and un-

screw it with the other hand.

Hold the overflow container level to prevent liquid

‒

from leaking out.

18 FAQs

18.1 Using the appliance

Question

Why can I not switch on the

hob and why is the child-

proof lock symbol lit?

Why are the illuminated dis-

plays flashing and why is a

signal sounding?

The ventilation system does

not switch on even though

the automatic start is activ-

ated.

The ventilation system con-

tinues to run even though

the cooking zones have

been switched off.

The air intake is too weak.

Answer

¡ The childproof lock is activated. You can find further information about this func-

tion under

→ "Childproof lock", Page 12.

¡ Clean the surface of the control panel of any liquids or food residue. Remove any

objects that may cover the control panel.

You can find further information about deactivating the signal tone under

→ "Basic settings", Page 12.

¡ Manually activate the ventilation system or check the configuration of the auto-

matic start. You can find additional information about this in the section entitled

→ "Basic settings", Page 12.

¡ Manually switch off the ventilation system.

You can find additional information about this setting in the section entitled

→ "Basic operation", Page 9.

¡ Ensure that the grease filter is clean.

To find out how to clean and replace the filter, refer to the section entitled

→ "Cleaning and servicing", Page 14.

Empty the overflow container and rinse it out.

If required, unscrew the screw and clean the over-

flow container without the screw in the dishwasher.

Clean the overflow container before screwing it

back into place.

Ensure that the supply to the overflow container is

not blocked.

Remove any objects that have entered the appli-

ance once it has cooled down. To do this, remove

the grease filter. → Page 16

FAQs en