Bosch WTA74202ID Manual de instruções de instalação e funcionamento - Página 33
Procurar online ou descarregar pdf Manual de instruções de instalação e funcionamento para Secador Bosch WTA74202ID. Bosch WTA74202ID 40 páginas.
Imprimir página
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
ç on the display panel.
Dryer does not start.
Display panel goes off
and Start button flashes.
Programme terminates
shortly after starting.
The door opens by itself. Push the door closed until you hear it engage.
Creasing.
Water is leaking out.
Laundry is not dried cor-
rectly or is still too damp.
* depending on the model
Cause/remedy
Clean the fluff filter. Select the Start button to reset the displayed indication
■
and then select the Start button again to restart the appliance if necessary.
Check if exhaust air duct is blocked or bent. Clean the exhaust air duct
■
~ Page 32. If necessary, clean the insect screen on the exhaust air pipe.
Mains plug plugged in or fuse checked?
■
Start button selected?
■
Dryer door open? Close the door.
■
Program selected? Select a program.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Program starts after a delay.
■
Not a fault. Energy saving mode is active ~ Page 13.
Ambient temperature greater than 5 °C?
■
Is the appliance loaded with the laundry?
■
Load too small for selected programme? Use timed programme.
■
Loaded laundry dry?
■
Creasing occurs when you have exceeded the maximum load or selected the
■
wrong program for the type of fabric. All the required information can be
found in the program table.
Remove clothes immediately after drying. Creasing may occur if they are left
■
in the drum.
Not a fault. The dryer may be positioned on an incline. Level the dryer.
After the end of the program, warm laundry feels damper than it actually is.
■
Spread the laundry out and allow the heat to disperse.
Finely adjust the dryness level – this extends the drying time but does not
■
increase the temperature. Your laundry will become drier ~ Page 27.
Select a program with a longer drying time or increase the drying level. This
■
does not increase the temperature.
Select a timed program for subsequent drying of laundry that is still damp
■
~ Page 25.
If you have exceeded the maximum load for the program, the laundry may
■
not be dried properly.
Clean the moisture sensor in the drum. A fine layer of limescale or particles
■
from the detergent and care products used in washing may residue on the
sensor and adversely affect it performance. It may cause that your laundry
will not dry properly ~ Page 32.
Drying has been interrupted as a result of a power cut, because the conden-
■
sate container is full or because the maximum drying time has been
exceeded.
See also the laundry tips ~ Page 24.
Note:
Faults and what to do about them
en
33