Bosch WTC84100IN/12 Manual - Página 4
Procurar online ou descarregar pdf Manual para Secador Bosch WTC84100IN/12. Bosch WTC84100IN/12 8 páginas.
Imprimir página
g the dryer for the first time
cycle without any laundry
see page 7.
Inspecting
the dryer
nnecting the
mains plug
oading laundry
he programme
1
drying programme ...
2
idual requirements
view,
see page 7.
3
Start/Stop button
nly operate the dryer
th the fluff filter inserted.
Drying
Control panel
Drum
Fluff filter
Air inlet
Condensate container
Drying
Emptying condensation
Empty the container after every use.
1.
Remove the condensate container and hold it
level.
2.
Open the locking cap.
3.
Pour out the condensation.
Check the valve in the condensate container for dirt:
If there are fluff deposits on the valve
water. Also pour some tap water into the empty condensate
container then pour it out again through the valve.
To do this, press the valve in and allow all the water to drain out.
4.
Regularly remove any deposits in the locking cap hole
using a pointed object.
5.
Close the locking cap.
6.
Always push the tank fully back in until it locks in place.
If the Container empty
/ Clean
after emptying the container
see page 10.
Cleaning the fluff filter
Clean the fluff filter after every use.
1.
Open the door. Remove any fluff from the door/around the door and pull
out the fluff filter.
2.
Remove the fluff from the shaft of the fluff filter. Ensure that no fluff falls
into the open shaft.
3.
Open the fluff filter and remove the fluff (sweep your hand over the fluff
filter). If the fluff filter is very dirty or blocked, rinse with warm water and
dry thoroughly.
4.
Close and reinsert the fluff filter.
Switching off the dryer
Set the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
Your dryer has an automatic anti-crease function. The drum is moved at set intervals for 30 minutes after
the programme has ended. Laundry remains loose and fluffy (for 90 minutes, if additional
function is selected - depending on model).
End of programme
as soon as Ready/Anti-Crease
Adding or removing laundry
The drying cycle can be interrupted in order to add or remove laundry.
The programme must then be continued or ended.
The drum and the door may be hot!
1. Open the door. The drying process is interrupted.
2. Load or remove laundry and close the door.
3. If required, select a new programme and additional functions.
4. Press the
Start/Stop button.
3
rinse the valve under running
/
indicator light comes on
/
indicator light flashes
Easy Iron
4