Community HSB3-BFR22 Manual de instruções - Página 9

Procurar online ou descarregar pdf Manual de instruções para Amplificador Community HSB3-BFR22. Community HSB3-BFR22 12 páginas. Balancepoint flyware for point source and subwoofer loudspeakers models ip8, ip6, is8, and is6, dual vertical splay with extension kit for 2-way models

Imprimir página
ROTATIONAL (HINGE) BRACKET (continued)
GENERAL ROTATIONAL (HINGE) BRACKET INFORMATION
Figures showing the basic assembly and how to secure the angles are
shown below.
IMPORTANT: Each hinge is shipped preassembled with a 10mm hinge
bolt and locknut fastened to allow some movement. Once the angle is
permanently set (and confirmed by commissioning the system), the locknut
should be tightened to prevent any movement. Do not remove the locknut
or hinge bolt for any reason.
Each hinge assembly also has two 6mm fasteners with finger-tight lock
nuts inserted into angle selection holes on each side of the hinge. Both 6mm
fastener sets may be removed for assembly but must all be re-inserted and
fully tightened in accordance with each kit's specific assembly instructions.
Angles may be adjusted in 2.5° increments from 0° to 45° in any array
configuration. Although it is possible in some configurations, do not exceed
a splay angle of 45° (between adjacent sides).
HW1
HW1
HN1
Hinge (rotational bracket)
assembly exploded
(shipped preassembled)
I SERIES
HN6
HH1-12
PH
HH6
PH
HW6
HN6
Secure angle with 6mm fasteners.
The hinge is shipped with the
fasteners in the 45° holes.
BalancePoint™ Flyware
HH6
HW6
HH6
HN6
HW6
Horizontal arrays
Vertical arrays
Best practices: Orient the fasteners in
the hinges to follow the direction of
gravity; i.e. if the hinge will be used
with the hinge bolt vertically oriented,
position the hinge with the nut at the
bottom to prevent the bolt from falling
out if the nut should loosen.
Use the four inner
attachment points for HSB,
HVS, or VSB kits
Use the four outer attachment points in
DFS and DVS-BFR22 configurations
The hinge brackets have 2 sets of holes
to attach the hinges to the cabinets. Bolt
placement diagrams showing connection
to the cabinet brackets are in each of the
individual kit instructions.
Page 9