Community Controls 318DOPW2KC MONARCH Manual - Página 4
Procurar online ou descarregar pdf Manual para Transmissor Community Controls 318DOPW2KC MONARCH. Community Controls 318DOPW2KC MONARCH 4 páginas.
Imprimir página2 - NUMBERING
Each transmitter is manufactured and sold with a different factory-set serial
number .
3 - PROGRAMMING
The transmitter must be programmed into your system memory.
Your own installer or reseller will provide you the necessary instructions for your
system.
4 - OPERATION
A - Firmly depress the button until the small red LED illuminates.
B - After the LED has illuminated, release the button.
If the device you are attempting to activate does not respond, repeat steps A and B
or consult section 7 ( Troubleshooting ) of this manual.
5 - BATTERY ACCESS
To access the battery open the case with a screwdriver acting on the slot between
the cover and the bottom and remove the bottom, as shown in fig. 3a and 3b.
Slide out the old batteries and replace them with the new ones [CR2016]
respecting the polarity, with the positive (+) side upward.
NOTE: Please dispose of the batteries properly according to local laws and
regulations. Test proper battery installation by verifying that the LED illuminates
when the button is pushed.
6 - BATTERY STATUS
Battery level
Led color
Led GREEN
Normal level
Led ORANGE
Attention level
Led RED
Low level
Fig. 3a
Fig. 3b
TX Status
~6000 pulses [*] - Normal range
Max 300 pulses
[*]
- Low range
Replace battery - No range
[ * ] : Depends on batteries type and operating conditions . Batteries life calculated
with 1-sec pulses.
7 - TROUBLESHOOTING
PROBLEM
The system does not receive the
transmitter signal.
The transmitter LED is ON
The operating range is reduced
Community Controls - Type : 318LIPW2KC
FCC ID : SU7318LIPW2KC
This device complies with
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept interference received, including
interference that may cause undesired operation.
Any changes or modification to
approved by
Community Controls
The warranty period of Community Controls 318 transmitters is 24 months,
beginning from the manufacturing date of the transmitter. During this period, if the
product does operate correctly, due to a defective component, the product will be
repaired or replaced at the sole discretion of Community Controls.
The warranty does not extend to the transmitter case which can be damaged by
conditions outside the control of Community Controls or to battery life.
2500 South 3850 West, Suite A - Salt Lake City, Utah 84120
www.communitycontrols.com - [email protected]
SOLUTION
Check to verify the transmitter is
programmed into your system
Replace the transmitter batteries
Part. 15 of the
FCC Rules
Notice
Community Controls
equipment not expressly
could void the manufacturer's warranty.
WARRANTY
IS-TM23LCCUK Rev. 0 del 05.03.2013