Andersons Model2000 Manual - Página 5

Procurar online ou descarregar pdf Manual para Espalhador Andersons Model2000. Andersons Model2000 8 páginas. Professional rotary spreader

Calibration Instructions

Your professional spreader has been factory calibrated. For best results, occasionally check

calibration and adjust if necessary.

1) Set the rate control plate to the "E" position.

2) Push the main shutoff lever to the OPENposition.

3) Insert the calibration key vertically into the center

port hole, as shown in the accompanying diagram.

4) If the calibration key fits snugly, the spreader is

properly calibrated. If not, continue with steps 5-12.

5) Loosen the rate control knob and slide the rate

control plate all the way to the left.

6) Insert the calibration key as described in Step #3.

7) Pull the main shutoff lever back to ease the shutoff

plate against the calibration key. Use the main shut

off leverto hold the calibration key in place.

calibration

depth

8) Slide the rate control plate to the right until it comes

in contact with the protruding end of the rate control

rod.

9) Tighten the rate control knob.

10) Remove the calibration key and pull the main shut

off lever to the closed position.

11) Loosen the nuts securing the rate control pointer

and slide the pointer so that it centers on the "E"

setting of the rate control plate.

12) Re-tighten the nuts on the pointer.

Calibration Key

Pointer

"E" Position

Rate Control Plate