Carolina Extreme Duty XBC-8 Manual do proprietário/operador - Página 10
Procurar online ou descarregar pdf Manual do proprietário/operador para Cortador de escova Carolina Extreme Duty XBC-8. Carolina Extreme Duty XBC-8 16 páginas.
Imprimir página
operation and performance of the
Omni engineered bearing housing.
Fill
Level the cutter attachment. Remove
both of the plugs shown above. The oil
level is to be at bottom of the plug. If
oil level is low, add
lubricant to the housing in one hole
until the oil level is at the bottom of
the second hole. Replace and tighten
the plugs.
Before Every Use
Check that all fasteners (nuts, bolts,
pins, keepers) are in their right place
and are tight.
Inspect and replace any worn, torn or
missing safety decals.
Investigate the location of any oil leaks
and repair.
Check the hydraulic oil level in the skid
steer. Add the recommended oil, if
necessary.
Every Week
Check the condition of the blades by
raising the cutter attachment off the
ground and tilt the attachment
forward to the 90° position. Lower the
attachment to the ground.
Inspect the cutter blades and remove
and sharpen them if necessary. Sharp
cutter blades will cut more efficiently
than dull blades.
Carolina Attachments LLC.
r Plug
5EP
85W-140
Page 10
After Every Season
Inspect the implement for any loose or
worn parts that may need to be
replaced prior to the next cutting
season.
Visually inspect the cutting blades.
Sharpen or replace them, if necessary.
Clean, sand & repaint any area that
looks worn or scratched to prevent
further rusting. Use an equipment-
paint found at your local hardware
store or building center.
Store your implement in a shed or
cover with a water-proof tarp to
protect it from the weather. Store in
an area not frequented by children.
Blade Holder Removal
& Installation
Removal:
Tilt the skid steer's tool cylinder all the
way back to place the attachment in a
near vertical position. Secure the front
of the cutter with an overhead hoist or
prop a 4" x 4" under the front or lean
the cutter head against a large tree to
support it in the raised position.
during the following step. The blade
cutter could fall resulting in Minor or
Serious Injury. Stand to the side.
Remove the six
/
" cap screws that
3
4
secure the holder to the gearbox shaft.
If holder cannot be removed, start the
skid steer and place the cutter level
and jar the cutter on the floor or
ground surface. The holder should
separate from the gearbox flange.
Repeat if necessary.
Extreme Brush Cutters
Be cautious
September 2018