DREAMS 769-00445 Manual - Página 7

Procurar online ou descarregar pdf Manual para Almofada de aquecimento DREAMS 769-00445. DREAMS 769-00445 11 páginas. Sherpa fleece heated throw

Operating the Controller

Firstly, slide the ON / OFF switch upwards so the notch on the switch is aligned with

the number "1".

You will notice two red numbers in the LED display. The number on the left refers to

the heat setting and the number on the right refers to the countdown timer setting.

Press the "Temp" button repeatedly to select your desired heat setting. Setting "0"

has no heat setting. Setting "1" gives the lowest heat with "9" being the maximum.

Press the "Timer" button repeatedly to select the desired operating hours. The

numbers 1-9 are shown in hours and "H" represents 12 hours. The blanket will

operate until the selected time period has elapsed. When the time has run out the

blanket will stop heating and the LED display will switch off. To restart the blanket,

slide the ON / OFF switch downwards to "0" and then upwards to "1".

If using for a prolonged period of time it is recommended to set the temperature

setting to "9" for the first hour and then decrease the setting to between "1" and

"4" for the remaining time.

Important: When the blanket is not in operation, please slide the ON / OFF switch

downwards to "0" and disconnect from the mains power supply.

Sherpa Fleece Heated Throw - Page 7