Comnet RELIANCE RLGE2FE16R Manual de início rápido - Página 15
Procurar online ou descarregar pdf Manual de início rápido para Interruptor Comnet RELIANCE RLGE2FE16R. Comnet RELIANCE RLGE2FE16R 18 páginas. Substation-rated, enhanced security scada-aware ethernet layer 2 managed switch/layer 3 router with optional 2g/3g & 4g lte cellular radio link, enhanced network security, terminal server, poe+, and 100fx sfp ports
Imprimir página
QUICK START GUIDE
Check Vlan IP addresses by typing show ip interface
RLGE2FE16R# show ip interface
vlan1 is up, line protocol is up
Internet Address is 10.0.0.0/8
Broadcast Address
Create management VLAN
Give management VLAN an IP address
» Enter global configuration mode by typing Configure Terminal in the command line you will
see RLGE2FE16R(config)#
» Enter vlan interface you wish to set an IP address for (Format will be ip address (a) subnet mask
(b) a.a.a.a b.b.b.b)
» Followed by no shutdown command to make sure vlan is not shut down
› Exit will be used to exit the interface
› Now you set up layer 2. Enter Vlan x and add ports to the vlan.
› Once done, use end to exit back to root mode
› Enter wr st (write startup) to save all configurations
RLGE2FE16R(config)# interface vlan 1
RLGE2FE16R(config-if)# ip address 10.10.10.1 255.255.255.0
RLGE2FE16R(config-if)# no shutdown
RLGE2FE16R(config-if)# exit
RLGE2FE16R(config)# vlan 1
RLGE2FE16R(config-vlan)# ports fastethernet 0/1-8 gigabitethernet 0/3 untagged fastethernet
0/1-8
RLGE2FE16R(config-vlan)# end
RLGE2FE16R# wr st
Building configuration ...
[OK]
% startup-config saved successfully
RLGE2FE16R# █
» You now need to add ports to specific vlans.
› Enter into global config once again (Conf t)
› Enter the interface you wish to add to the vlan and set Port vlan ID to the vlan number
TECH SUPPORT: 1.888.678.9427
10.0.0.255
RLGE2FE16R
QSG_RLGE2FE16R_REV– 3 Aug 2016 PAGE 15