Bosch 23612 Manual de instruções de funcionamento/segurança - Página 3
Procurar online ou descarregar pdf Manual de instruções de funcionamento/segurança para Perfurar Bosch 23612. Bosch 23612 41 páginas. Operating instructions
Imprimir página
Maintain tools with care. Keep cutting
tools sharp and clean. Properly maintained
tools with sharp cutting edge are less likely to
bind and are easier to control.
Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that may affect the tool's
operation. If damaged, have the tool
serviced before using. Many accidents are
caused by poorly maintained tools.
Use
only
accessories
recommended by the manufacturer for
your model. Accessories that may be
Hold tools by insulated gripping surfaces
when performing an operation where the
cutting tool may contact hidden wiring or it
own cord. Contact with a "live" wire will make
exposed metal parts of the tool "live" and
shock the operator. Do not drill, fasten or break
into existing walls or other blind areas where
electrical wiring may exist. If this situation is
unavoidable, disconnect all fuses or circuit
breakers feeding this worksite.
Always wear safety goggles or eye
protection when using this tool.
Wear ear protectors when using the tool for
extended periods. Prolonged exposure to
high intensity noise can cause hearing loss.
Use thick cushioned gloves and limit the
exposure time by taking frequent rest
periods. Vibration caused by hammer-drill
action may be harmful to your hands and
arms.
Secure the material being fastened. Never
hold it in your hand or across your legs.
Unstable support can cause loss of control
and injury.
Avoid accidental starting. Be sure the
forward/reverse switch is in the off
position before inserting battery pack.
Carrying appliances with your finger on the
switch or inserting the battery pack into an
appliance with the switch on invites
accidents.
that
Safety Rules for Cordless Drivers
suitable for one tool may create a risk of
injury when used on another tool.
Tool service must be performed only by
qualified repair personnel. Service or
maintenance performed by unqualified
personnel may result in a risk of injury.
When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual.
are
Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of
shock or injury.
Remove battery pack before changing
accessories. Accidental starting may occur
because battery appliances with a battery
inserted are in the operative condition.
Be prepared for a reaction torque when
"seating" or removing a fastener. The
screwdriver housing may tend to twist in the
opposite direction of bit rotation when
"seating" or removing a fastener depending
on the torque setting of the tool.
Do not use dull or damaged bits and
accessories. When installing an accessory,
insert the shank of the bit well within the
collet. Be sure the collet has locked onto the
bit correctly.
Do not run the tool while carrying it at
your side. A spinning bit could become
entangled with clothing and injury may result.
Place the tool onto the fastener only when
the screwdriver is switched off. Rotating
driver tools can slide off the fastener.
Do not use this tool as a drill. Tools
equipped with shut-off clutches are not
designed for drilling applications. The clutch
can shut off automatically and without
warning.
Be careful when driving long screws –
there is a risk of sliding off the fastener
head depending on type of socket or bit
used. First test the run-down of a fastener
-3-
Service