Electrolux EGG 690 Folheto de instruções - Página 9

Procurar online ou descarregar pdf Folheto de instruções para Hob Electrolux EGG 690. Electrolux EGG 690 16 páginas. Electrolux gas hob instructions egg 690

Imprimir página

Cut Out Size

The dimensions of the cut-out are given in the diagram.

FO 2098

Building In

Building over a cupboard or

drawer

If the hob is to be installed above a cupboard or drawer

it will be necessary to fit a heat resistant board below

the base of the hob on the underside of the work

surface.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

Building over a kitchen unit

with door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the

bottom of the hob which can be heated when it is

operated. The recommended solution is shown in

diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical

assistance is needed. The space behind the kitchen

unit ("b") can be used for connections.

Fitting the hob to the

worktop

Before fitting the hob into the cut out, an adhesive

seal must be fitted to the underside outside edge

(diagram 4) of the hob. It is essential that no gaps

are left in this seal in order to prevent spillage near

the hob seeping into the cabinet below.

1) Remove the pan supports, the burners caps

and crowns and turn the hob upside down,

taking care the ignition candles are not

damaged in this operation.

2) Place the sealing gasket all around the

glass top edge as shown in diagram 4.

3) Fit the hob in the cut out and push it down

until the glass top and the working top make

contact, as shown in diagram 5.

ON/OFF SWITCH

FLEX

OUTLET

FO 0764

Dimensions are given in mm.

FO 2108

FO 2107

a) Sealing gasket

ON/OFF SWITCH

FLEX

OUTLET

FO 0763

FO 1013