ATL ATU Telex Unit Manual de operação e instalação - Página 10

Procurar online ou descarregar pdf Manual de operação e instalação para Modem ATL ATU Telex Unit. ATL ATU Telex Unit 16 páginas.

Imprimir página
Host Connection
The following are the connections available on the Host Port; the unit
is configured as a DCE. The cable from the Host computer should
terminate in a 25-pin Male D-type connector.
Pin Host
1
Earth
2
Tx (to the unit)
3
Rx (from the unit)
4
RTS (to the unit)
5
CTS (from the unit)
6
DSR (from the unit)
7
0V (common)
20 DTR (to the unit)
AUX Connection
The following are the connections available on the AUX Port. The
cable from the printer should terminate in a 9-pin Female D-type
connector.
Pin AUX
1
Earth
2
Rx (from unit to printer)
3
TX (not used in printer mode)
4
DTR (to the unit)
5
0V (common)
6
DSR (from the unit)
7
RTS (to the unit)

4. CONFIGURATION

Configuring the ATL Telex Unit
The ATL Telex Unit is configured by changing the various options in the
unit's software configuration menu accessed from a terminal session
through the Host port. This section contains a complete list of all
current options for both Host and Printer configuration.
If
an
RS232
communication, is connected to the Host connector, only Tx, Rx,
Ground and DTR connections are required by the Telex Unit for
terminal
or
computer,
10
using
asynchronous