Alera ALE-SB624234 Montagem rápida - Página 3

Procurar online ou descarregar pdf Montagem rápida para Mobiliário de interior Alera ALE-SB624234. Alera ALE-SB624234 4 páginas. Bookcase

Imprimir página
Step 3
Bottom Assembly
-
A)
Position the Kick Plate (I) as illustrated and
begin installation by lifting its right end
upwards inside the channel on the Right Side
Panel B).
B)
Push the Kick Plate upwards until the
crescent tab on the Side Panel engages
the square hole on the Kick Plate (I).
Note: this is a tight fit. A loose connection
would result in an unstable unit.
C)
IMPORTANT: Bend the tab on the bottom of the
Side Panel 45 degrees inward to lock the Kick Plate
in place.
D)
Repeat the procedure for the left side of the Kick Plate.
Cresent Tab on Side Panel
Square Hole
on Kick Plate
IMPORTANT:
T
he notched corners on the
Bottom (H) must face the Back
Panels
E)
Install the Bottom (H), by placing it in the bookcase with the notched corners
toward the Back Panels.
F)
Angle the Bottom (H) as illustrated and engage the supports located on the
two Back Panels. Note: as with the tabs, some adjustment to the supports on the
Side and Back Panels with the screwdriver may be necessary.
G)
Gradually tilt the front edge of the Bottom (H) forward, making sure that it engages
the supports located on the Right and Left Side Panels and goes over the bend on
the front of the Kick Plate (I).
H)
Carefully stand the unit upright and tap the Bottom (H) down. Make sure the
Bottom (H) has full engagement in the supports on the Back and Side Panels.
Quick Assembly Bookcase
NOTE: Kick Plate
fits inside the bend
on the Side Panel
Lift Kick Plate
into the channel
until it locks
Bottom - H
Channel
Right Side Panel - B
Angle the Bottom to engage the supports on the Back and Side Panels.
Tilt it forward until it's front edge goes OVER the bend on the Kick Plate.
The Bottom (H) must engage
the supports located on each
of the Back and Side Panels
Support
The Kick Plate slides into the
channel on the Side Panels and
locks into place.
Bend tab
45 degrees
inward to
lock the
Kick Plate
Carefully stand
the unit upright
Tap Bottom down
to fully engage
the supports
The Bottom must fully engage the supports located on
the Back and Side Panels
Page 3
Kick Plate - I
Tab bent
and Kick
Plate
locked in
position
The front edge of
the Bottom is
OVER the bend
on the Kick Plate