Andonstar AD205 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Microscópio Andonstar AD205. Andonstar AD205 8 páginas.

(P3 connect )

Quick start

Note

1. To give you good experience, please adjust the microscope and plastic bracket before using, then

remove the screen guard film on the screen.

2. If the light barrier is not over the bottom light, please adjust its position.

Connect

Firstly, connect the optical stack to the power supply via the switch cable. See the picture(P3) above.

This microscope supports battery(18650), it's not included in the package, please purchase separately.

Switch on

Then press and hold the Power button (on/off

) underneath the display until the display turns on.

(It may turn on automatically while connecting cables at the first time, and it's totally fine. )

*Troubleshooting

If the display freezes, locate the "reset " hole on the back of the monitor. Use a narrow object such as

an unfolded paperclip to depress the button located inside.

This resets all settings to their factory

values and restarts the display. It does not erase saved images or video.

①Use the large knobs (Colored knob) on the bracket to raise or lower the optical stack to the desired

height.

The lower the height,

the greater the magnification is.

But be careful not to let the bottom

of the stack contact the object being imaged. Turn the Focus controller to focus the image.

②To increase the digital magnification, press and hold the Up button ('

Button' ) until the desired