andover SPINSUB Manual do produto - Página 7

Procurar online ou descarregar pdf Manual do produto para Subwoofer andover SPINSUB. andover SPINSUB 12 páginas.

How to Connect your Source

Spinsub has beed optimized for use with Spinbase, but it also may be used with

other source

components.

It requires a source component that has a

line-level

output controlled by

its

volume control. This may be labeled in a number of ways,

depending on your source component. Most common are:

Pre-Out (or Preamp out)

•

Subwoofer

Line Out

Aux Out

An RCA to Miniplug adapter cable is included with Spinsub to facilitate use with

sources other than

Spinbase.

Spinsub does not accept speaker-level inputs. If

you wish to add Spinsub to a system that has only Speaker level output, you must

use a Line Output Converter accessory.

IMPORTANT NOTE

Spinsub is compatible with Spinbase units that have a separate Line output only.

Earlier Spinbase units with only a Headphone jack output are not compatible, but

may be updated at a nominal cost. Contact [email protected] for more

information.

Using Spinsub

Turn on the main power using the rear panel switch. The green LED will illumi-

nate.

It is not necessary to switch the power off between listening sessions. Spinsub

has automatic signal sensing. When a signal is present, Spinsub will wake from

standby and begin playing. It will reenter standby after a few minutes of no sig-

nal.

If there is excessive hum or noise in the input signal, Spinsub may not enter

standby. If this occurs please identify the source of the noise and eliminate it for

the most satisfying

experience.

The LED indicates status. The LED glows brightly when Spinsub is active, and

will extinguish when the unit is in

standby.

If the LED remains off when signal is

present, Spinsub is not receiving power or the main power switch has not been

turned on.

Page 8