Compac TJ-T2000 Manual de instruções - Página 2

Procurar online ou descarregar pdf Manual de instruções para Valetes Compac TJ-T2000. Compac TJ-T2000 11 páginas. Transmission jack

Instruction Manual (GB)

Transmission jack, TJ-T2000, TJ-T2000 G2

Important: Read and understand this manual before use!

Responsibility of the owner and-or the machine operator:

These instructions are an essential part of the crane and must always follow it, even in case of

sale.

The owner and/or the operator of the crane shall understand the product operating and warning

before operating the workshop crane.

If the operator is not fluent in English, the product instructions and warnings shall be read to and

discussed with the operator in the operator's native language, making sure that he understands its

contents.

The constructor is not liable for damages to people or things due to unfit or unallowed of the jack.

PACKING:

The transmission jack is sent into cartoon box package in the following pieces.

1 saddle - 2 trolleys - 1 jack body - 1 little bag with 4 pivoting kits.

ASSEMBLING:

Open the packages while checking that the machine has not suffered any damages in transit and

that all pieces in the packing list are present. The packing material is to be recycled or used again.

Apply the 4 pivoting wheels to the 2 trolley ends and block them looking the nut and washer.

Fix without locking the 2 trolleys down to the pump by mean of the hexagonal head screws and

relative washers. Lock the carriages bolts to the jack only after checking that the outside rod is set

at right angles to an horizontal plane.

Insert the saddle on the rod end.

Before operating the jack, replace the oil plug on the cylinder with the holed one

supplied by the manufacturer.

Test the jack lifting first without load, then with the rated load. (Attention! Respect the load capacity

shown on the jack.)

OPERATION:

Lifting: Pump on the pedal of the jack by a foot.

Lowering: Turn slowly the release valve to the left.

Safety rules:

The use of this jack is limited to the removal and installation of transmissions and differentials.

When loaded, the transmission jack may be used on a short flat way and only with the jack in the

lowest position, with the rod completely inside. Check, that during transport the load does not swing

and suddenly fall.

Do not overload! Overloading may cause damages to persons or things.

It may be used with appropriate adapters manufactured especially for the jack to handle other

components, such as rear units and transfers cases, within the limitations specified.

Be sure that the vehicle is appropriately before repairs.