Andover Controls ACC EMX 150 Manual de instalação - Página 3
Procurar online ou descarregar pdf Manual de instalação para Controlador Andover Controls ACC EMX 150. Andover Controls ACC EMX 150 4 páginas.
Imprimir página
Wire Current Outputs
You wire the outputs for current as follows:
Caution
Remember that the current sources to ground.
1.Slip the appropriate wire under the I screw and tighten
the screw down on it.
Figure 5 illustrates the wiring for current outputs.
2.Slip the ground wire under the RET screw and tighten
the screw down on it.
Figure 5. Wiring Diagram for Current Outputs
I
RET
Warning
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial
environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and
used in accordance with the instructions in this manual,
may cause harmful interference to radio communica-
tions. Operation of this equipment in a residential area
is likely to cause harmful interference in which case the
user will be required to correct the interference at his
own expense.
www.PDF-Zoo.com
Click for EMX Menu
RL < or = 750 Ω
EMX 150 Installation Guide 3
Adjust the Outputs
and Troubleshoot
Each output ranges from 0 to 20 V. Before you adjust the
output, attach a Volt-Ohm Meter to the output.
Use a flathead screw driver and turn the potentiometer la-
beled A to adjust output A.
Do the same for output B. For more information on how
to adjust the outputs and assign output numbers, see the
Andover Controls Infinity CX Programmer's Guide.
If you have problems with the Infinet controller after in-
stalling the module, see the Andover Controls Infinet
Controller Troubleshooting Guide.
Refer to the EnergyNet and Infinet Configuration and
Troubleshooting Guide for information on how to
troubleshoot network and power supply problems.
Note
This digital apparatus does not exceed the Class A limits
for radio noise emissions from digital apparatus set out
in the Radio Interference Regulations of the Canadian
Department of Communications.
Avis
Le présent appareil numérique n'émet pas de bruits ra-
dioélectriques dépassant les limites applicables aux
appareils numériques de la class A prescrites dans le Rè-
glement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.