Compac OPT SCR200 Manual de instalação - Página 16

Procurar online ou descarregar pdf Manual de instalação para Unidade de controlo Compac OPT SCR200. Compac OPT SCR200 18 páginas.

Imprimir página

Tank Gauging Setup

Tank gauging is wired into the terminals marked Tx, Rx and G.

The tank gauging unit will have to be set up with the correct outputs to communicate with the

FMS board. Settings depend on the unit.

Type

Mode

Veeder Root

Serial

Franklin

Veeder Root

Colibri

Veeder Root

The Compac settings for each model of tank gauge are usually either set at the factory or

sent via CompacOnline.

System and Transaction Tests

When you are happy that the OPT is powered up and communicating, contact the Help

Desk. The Help Desk will check that the OPT is communicating correctly and will ask you

to perform various checks to confirm this.

The exact site test setup and procedure will vary from customer to customer but as a

minimum we would suggest the following:

▪ Check that the current price is correct.

▪ Check each dispenser making sure the correct price has been applied.

▪ Dispense fuel from each pump on site, confirming that the correct pump is

authorised when requested and you are able to dispense fuel.

▪ After dispensing fuel, check the receipt and make sure the correct dollars, litres,

fuel grade and site details are printed on the receipt.

▪ Test the VoIP help phone function if fitted.

▪ The Help Desk will open CompacOnline and check that the transactions have

been recorded correctly. They will also check that the tank gauging is active and

sending back the correct levels.

▪ If your initial test transactions were completed with the OPT door open, you will

need to close and lock the cabinet and perform your transaction tests again.

▪ Complete the Install Checklist.

Baud Rate Parity

Bit

1200

Odd

7 Bit

9600

8 Bit

9600

8 Bit

11.

1 Stop Bit

Handshake

Yes

Off

Yes

Off

Yes

Off