Dresser RCS Manual de instruções
Procurar online ou descarregar pdf Manual de instruções para Ventilador Dresser RCS. Dresser RCS 19 páginas. Rotary lobe blowers
Imprimir páginar
ROOTS
$2.00
INSTRUCTIONS
ROTARY LOBE BLOWERS
CONTENTS
NUMBERS IN ( ) ARE METRIC EQUIVALENTS
INFORMATION SUMMARY ........... This page
Receiving ... Installing ... Operating
OPERATING CHARACTERiSTiCS ............. 2
Description ... Control ... Protection
OPERATING LIMITATIONS .................. 2
Pressure ... Temperature ... Speed
INSTALLATION. . . . . . . . . . . . . . . . . . . . . . . . . . .. 3
Mounting ... Aligning ... Piping
LUBRICATION ............................. 6
Oil System ... Sealing ... Servicing
OPERATION ............................... 6
Starting ... Checking ... Running
TROUBLE SHOOTING ....................... 7
Capacity ... Power ... Heating
SAFETY PREACUTIONS. . . . . . . . . . . . . . . . . . . .. 8
Physical ... Operating ... General
MAINTENANCE/REPLACEMENTS ............ 8
Servicing ... Repairs ... Clearances
PARTS DRAWiNGS ......................... 13
DISTRIBUTORS ............................ 20
DO THESE THINGS .... To Get The Most From Your Roots Blower
IICheck shipment for damage in transit. After filing
claim with carrier, notify nearest Sales Office or factory.
ElUnpack shipment carefully and check contents
against Packing List. Notify Sales Office or factory if a
shortage appears.
BlStore in a clean, dry location until ready for
installa~
tion, if possible. Lift by methods discussed under IN-
sTALLATION to avoid straining or distorting the equip-
ment. Keep covers on all openings. Protect against
weather and corrosion
if
outdoor storage is necessary.
LIMITATIONS and INSTALLATION sec-
tions in this manual and plan the complete installation. If
supervision by a Service Engineer is needed, contact the
nearest Dresser Parts and Service Center at least two
weeks in advance and confirm by your purchase order.
Standard charges will be made.
IDProvide for adequate safeguards against accidents to
persons working on or near equipment during both in-
stallation and operation. See PRECAUTIONS.
iii
Install all equipment correctly. Foundation design
must be adequate and piping carefully done. Use recom-
mended accessories for operating protection.
IiIMake sure both driving and driven equipment is cor-
rectly lubricated before start-up. See LUBRICATION.
'::1
Read starting check points under OPERATION. Run
equipment briefly to check for obvious faults, and make
corrections. Follow with a trial run under normal
operating conditions.
mIn the event of trouble during installation or opera-
tion of a new unit, do not attempt repairs. Notify nearest
Sales Office or factory, giving all nameplate information
plus an outline of operating conditions and a description
of the trouble.
EUnits out of warranty may be repaired or adjusted by
the owner.
It
is recommended that such work be limited to
the operations described in this manual, using Factory
Parts. Good inspection and maintenance practices should
reduce the need for repairs. See Distributor List on last
page for parts and service after warranty period.
NOTE - Information In this manual is correct as of the date of publication. The Manufacturer reserves the right to make design or material changes without notice, and
without obligation to make similar changes on equipment of prior manufacture.
Bulletin IRB-115-387