Electrolux CH 910 Livro de instruções - Página 8

Procurar online ou descarregar pdf Livro de instruções para Campânula de ventilação Electrolux CH 910. Electrolux CH 910 21 páginas. Stylish stainless steel chimney hood
Também para Electrolux CH 910: Manual do utilizador (28 páginas)

Imprimir página

Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply.

Charcoal Filters

In the recirculation mode the charcoal ﬁ lters absorb smells and unwanted odours.

Enabling the alarm signal

• In Recirculation Version Hoods, the Filter saturation Alarm must be enabled at the time of installation or later.

• Switch off the lights and the motor.

• Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector,

switching off the power supply at the Mains or turning the Main switch off.

• Restore the connection, pressing and holding T2.

• Release the touch control, touch controls L, T2 and F will light up normally.

• Within 3 seconds press the touch control F until the key itself ﬂ ashes to conﬁ rm as follows:

• 2 ﬂ ashes – Charcoal odour Filter saturation Alarm ENABLED

• 1 ﬂ ash - Charcoal odour Filter saturation Alarm DISABLED

This ﬁ lter cannot be washed or regenerated, and must be replaced when the F touch control starts to ﬂ ash, or at least

once every 4 months. The alarm is only triggered when the motor is on.

To Remove/Replace the Charcoal Filters

• Remove the metal grease ﬁ lters

• Remove the saturated activated carbon ﬁ lter by

releasing the ﬁ xing hooks

• Fit the new ﬁ lter by hooking it into its seating

• Replace the metal grease ﬁ lters.

This appliance can be a possible ﬁ re

hazard if the grease and charcoal ﬁ lters

are not cleaned and replaced as recommended.

Alarm signal reset

• Stop the motor.

• Press the touch control F for at least 4 seconds, until

the touch control T1 ﬂ ashes.

Changing the Light halogen

• Remove the 2 screws ﬁ xing the Lighting support, and

pull it out of from the Hood.

• Extract the lamp from the Support.

• Replace with another of the same type, making sure

that the two pins are properly inserted in the lamp

holder socket holes.

• Replace the Support, ﬁ xing it in place with the two

screws removed as above.

MAINTENANCE AND CLEANING