Electrolux CH 910X Livro de instruções - Página 7

Procurar online ou descarregar pdf Livro de instruções para Campânula de ventilação Electrolux CH 910X. Electrolux CH 910X 21 páginas. Electrolux plc electrolux cooker hood instruction book ch 910

Imprimir página
To Operate
Select the required fan speed and light if required.
Recirculation
In the recirculation mode the contaminated air enters the cooker hood through the grease fi lters. The air is cleaned
by passing through the charcoal fi lters before being passed back into the kitchen through the grilles in either side of
the chimney stack.
Extraction
In the extraction mode the contaminated air enters the cooker hood passing through the grease fi lters and is passed
out through the ducting into the atmosphere.
To obtain the best performance when cooking it is advisable to switch the cooker hood on for a few minutes before
you start cooking and leave it running for about 15 minutes after fi nishing.
When used in the ducting mode the charcoal fi lters are not required.
Never do fl ambé cooking under this cooker hood.
Never leave frying pans unattended during use, as over-heated fats and oils can catch fi re.
Do not leave naked fl ames under the cooker hood.
Ensure heating areas on your hob are covered with pots and pans when using the hob and cooker hood
simultaneously.
Before carrying out any maintenance or clea-
ning isolate the cooker hood from the mains
supply.
The cooker hood must be kept clean, as a build
up of grease or fat can be a fi re hazard.

External Cleaning

Wipe the cooker hood frequently with warm
soapy water using a mild detergent.
Never use scouring pads or abrasive cleaners.
Never use excessive amounts of water when
cleaning particularly around the control panel.

Metal Grease Filters

The fi lters are washable and must be cleaned when the
F-Touch control lights up or at least every 2 months
of operation, or more frequently for particularly heavy
usage.
Remove the metal grease fi lters
one at a time by:
Releasing the catches on the fi lters, the
fi lters can be removed.
The metal grease fi lters should be washed, by
hand, in mild soapy water or in a dishwasher. Allow
to dry completely before replacing.
Alarm signal reset
Stop the motor.
Press the F-Touch control for at least 4 secon-
ds until the T1-Touch control fl ashes.
OPERATING INSTRUCTIONS

MAINTENANCE AND CLEANING

7